Owner's Manual
www.desatech.com
111244-01G26
REMOTE
OFF
ON
H
I
LO
IN
OUT
OPERATING FIREPLACE
Continued
Note: The burner may light if hand-held
remote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
againuntilburnerturnsoff(seeFigure49).
press both buttons on hand-held
remotecontroluntillightstopsashing.Hand-
heldremotecontrolisnowlocked.Ifthereis
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
press both buttons together
on hand-held remote control until the light
stops ashing.Thehand-held remote is now
unlocked.
Figure 48 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
Flame
Adjustment Knob
Control
Knob
Selector Switch in Remote
Position (Optional Remote Control)
Figure 49 - On/Off Hand-Held Remote
Control Unit
Control Button
Turns Burners
On and Off
THERMOSTAT SERIES (MODEL
The hand-held remote can be operated using
eitherthemanual mode(MANU)orthermo-
staticmode(AUTO)(seeFigure50).Toselect
Fahrenheit/Centigrade mode display, carefully
pressthe˚C/˚Fmodebuttonwiththeendofa
papercliporsimilarbluntobject.
Manual Mode
1.
Press the POWER and LOCK buttons together
to turn on the hand-held remote control.
2. Press the MANU button to turn on the
replace.
3. Press the POWER and LOCK buttons
togethertoturnoffthereplace.
1.
Press the POWER and LOCK buttons together
to turn on the hand-held remote control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by press-
ing the TEMP + or - buttons.
4. Press the POWER and LOCK buttons
togethertoturnoffthereplace
Note: Do not leave the hand-held remote in the
AUTOmodeclosetothereplace.Theradiant
heatfromthereplacewillturnoffthereplace.
Ideally, place the hand-held remote in the center
oftheroomfacingtowardsthereplace.
Indicator
Light
Figure 50 - Thermostat Hand-Held
Remote Control Unit
LOCK
MANU AUTO
ºC/ºF
TEMP
POWER
ROOM
TEMP
SET
TEMP
AUTO
Turns
Hand-Held
Remote On
or Off and
Allows You
to Choose
the Manual
Setting
Selects
AUTO
Mode
°C/°F
Mode
Button
Locks
System to
Prevent
Accidental
Ignition
Turns
Burners
On or
Off
Increases or
Decreases
Room
Temperature
in AUTO Mode
Digital Display Shows
Temperature and Settings