Owner's Manual
www.desatech.com
111244-01G 9
-
currents move heat to wall sur-
as, but not limited to, tobacco
smoke, aromatic candles, clean-
IMPORTANT: Vent-free replaces add moisture to
the air. Although this is benecial, installing replace
in rooms without enough ventilation air may cause
mildew to form from too much moisture. See Air for
Combustion and Ventilation, page 6.
Note: Your replace is designed to be used in zero
clearance installations. Wall or framing material can be
placed directly against any exterior surface on the rear,
sides, or top of your replace, except where standoff
spacers are integrally attached. If standoff spacers are
attached to your replace, these spacers can be placed
directly against wall or framing materials.
Note: When installing replace directly on carpet-
ing, tile or other combustible material, other than
wood ooring, the replace shall be installed on a
metal or wood panel extending the full width and
depth of the replace.
Use the dimensions shown for rough openings to
create the easiest installation (see Built-In Fire-
place Installation, page 10).
Use the correct gas type (natural or propane/LP)
for your unit. If your gas supply is not correct, do
not install replace. Call dealer where you bought
replace for proper type replace.
WARNING: This appliance
is equipped for (natural or pro-
INSTALLATION
NOTICE: This heater is intended
install this heater as your pri-
-
-
WARNING: Never install the
• in a bedroom or bathroom
• in a recreational vehicle
• where curtains, furniture,
from the front, top, or sides of
• in windy or drafty areas
WARNING: Never install in a
-