Owner's Manual

ManualsBrandsDesa Tech ManualsHeatersDesa Tech VFF KD 100

WARNING ICON G 001

WARNING

Carefully remove each mantel piece one at a time from shipping carton. Do not

try to lift all of the parts out of the box at once. This may damage mantel pieces.

Firebox

Perimeter Brass

Trim included

with this

Mantel

IMPORTANT:

Read entire instruction sheet before assembling or installing mantel kit.

This mantel is only approved for use with CGFP28 and LFP33 series natural gas and propane fireplace systems,

CGFB32 series fireboxes, and direct-vent gas fireplace systems CDV34 and CHD34 series. Do not use mantel with any

other product. Several optional accessories are available for this mantel kit. These accessories include the GC3333F

and G3334U series hearth base kits for hardwood mantels and GC3335FB series for oak mantels. Contact dealer to

purchase optional accessories.

This mantel kit contains the following pieces:

GMC11FC GMC12UC GMC13FC

Hardware 101472-01 101472-01 101472-01

Brass Trim Kit 102753-01 102753-01 102753-01

Trim Kit Hardware 102865-01 102865-01 102865-01

Mounting Blocks 101477-09 101477-09 101477-09

The hardware package contains the following:

•15 - 1 1/4" wood screws

•Colored finishing nails

Tools required

•#2 Phillips screw driver •Pencil

•Flat head screw driver •Drill

•Measuring tape

If any of these pieces are missing or dam-

aged, contact the dealer where you purchased

this kit or call DESA International’s Parts

Department at 1-800-972-7879 for referral

information.

Shown with Optional

Hearth Base

GMC11FC/GMC12UC Hardwood

and GMC13FC Oak

Cabinet Mantel

Assembly and Installation Instructions

Summary of content (4 pages)

PAGE 1
GMC11FC/GMC12UC Hardwood and GMC13FC Oak Cabinet Mantel Assembly and Installation Instructions ox Fireb rass eter B ed m i r e P includ Trim his with t l Mante Shown with Optional Hearth Base WARNING ICON G 001 WARNING Carefully remove each mantel piece one at a time from shipping carton. Do not try to lift all of the parts out of the box at once. This may damage mantel pieces. IMPORTANT: Read entire instruction sheet before assembling or installing mantel kit.
PAGE 2
GMC11FC, GMC12UC, and GMC13FC Mantels Assembly and Installation Instructions WARNING ICON G 001 WARNING Use care when finishing an unfinished mantel. Do not finish mantel pieces near running heater or open flame. Vapors from most finishing products are highly flammable. Follow manufacturer’s guidelines when using finishing products. IMPORTANT: If you are painting an unfinished mantel, apply an oil base undercoat to the mantel before painting. This will seal the wood.
PAGE 3
Header Top Header Right Side Side Face Boards Left Side Side Face Boards Figure 3 - Installing Header Figure 5 - Placing Mantel Top on Mantel Assembly Top Side 1 1/4" Wood Screws 1 1/4" Wood Screws Side 1 1/4" Wood Screws Header Figure 6 - Attaching Top Header WARNING ICON Mounting Block G 001 WARNING A qualified service person must install gas piping to heater. Follow all local codes. 6. Place mantel in desired location. Place firebox in front opening of mantel.
PAGE 4
8. From gas meter or propane tank, run hard piping to manual shutoff valve. You must install the manual shutoff valve within reach from heater. Install an approved flex hose (if allowed by local or state codes) for natural or propane gas to run from the manual shutoff valve to heater. 9. Connect heater to gas line according to instructions in heater owner’s manual. Check all connections for leaks from heater to gas meter or propane tank. WARNING ICON G 001 8.