Gas Heater User Manual

www.desatech.com
117437-01D 11
VENTING INSTALLATION
Continued
CHECKING FOR PROPER VENTING
    
     
instructions and allow main burner to run for
approximately 5 minutes. Hold a match or

       
entire length of opening (Smoke may also be

     
       -

Figure 12). Smoke will also tend to disperse
away from appliance.


agency to inspect venting system.
Figure 12 - Checking for Spillage
Figure 13 - Relocating Junction Box Recep-
tacle and Electrical Supply Connection
ELECTRICAL SUPPLY CONNECTION
CAUTION: Disconnect the
electrical power to the supply
circuit before attempting to con-
nect or service this appliance.

relief is provided on right side of cabinet for

grounded branch circuit. If installation demands

entire receptacle box can be relocated to the
left side by following these instructions:
J-Box
Cover
with Strain
Relilef
J-Box
Cover
Romex
Cable
J-Box with
Receptacle
J-Box Cover
with Strain
Relief
Screw/Tab
Retainer
Note: If you do not need to relocate the junc-
tion box, to connect the electric supply follow
steps 8 through 11 only:
1. Remove 2 screws and outer cover with
strain relief bushing on right side of cabi-
net (see Figure 13).
 
box mounting tab.
 
tab is lined up to notch in outer cabinet.
 

5. Remove 2 screws and outer cover on left
side of outer cabinet.
     
through slot now on left side and swing
screw mounting tab back through notch
as before.
 
holes line up and replace inner retaining
screw.
      
end of 3-wire Romex supply line through
universal strain relief bushing on cover.
(see Figure 13).
9. Strip back outer Romex to about 4" and
-
cordingly using 3 wire nut connectors.
     
-
ing screws.
    
bushing to secure Romex sheathing and
complete supply connection.