27" MODELS CGESBL AND VESBL 18" MODELS CGESBMR AND VESBMR ELECTRIC STOVE WITH REMOTE CONTROL SAFETY INFORMATION AND OPERATION MANUAL Read these instructions completely before operating electric stove. Failure to follow them could cause a heater malfunction resulting in serious injury and/or property damage. Save this manual for future reference. For more information, visit www.desatech.
TABLE OF CONTENTS Safety Information ............................................... 2 Listing Approvals ................................................. 3 Unpacking and Testing the Unit ........................... 3 Product DimensionS & Specifications ................. 3 Grounding Instructions ........................................ 4 Operating Instructions ......................................... 4 Cleaning and Maintenance .................................. 6 Technical Service .........................
SAFETY INFORMATION Continued 12. Always disconnect the unit from the power supply before performing any cleaning, light bulb replacement, maintenance, relocating the heater or when the unit is not in use for long periods of time. 13. When transporting or storing the unit, keep it in a dry location, free from dust, excessive vibration or other factors, which may damage the unit.
GROUNDING INSTRUCTIONS This stove is for use on 120 volts. The cord has a plug as shown in Figure 2. An adapter is available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is available.
OPERATING INSTRUCTIONS Continued 2. When operating the remote control, it must be pointed at the logset inside the electric stove and a beep must be heard each time you press a function button. The beep confirms the remote control is performing the function you have requested. Note: Make sure your batteries are fully charged and installed correctly in your remote control. 3. POWER ON/OFF button at the top left is the main ON/OFF power button.
CLEANING AND MAINTENANCE WARNING: Always disconnect power and allow the heater to cool before performing any cleaning, maintenance or relocation of this heater. Turn controls to OFF and remove plug from outlet or turn off circuit breaker to heater. Turn off heater and circuit breaker to heater before performing any cleaning and/or maintenance. Allow heater to cool completely. BULB REPLACEMENT WARNING: The halogen light bulbs in your unit can become extremely hot.
CLEANING AND MAINTENANCE Continued Replacing Log Set Ember Bed Bulbs 1. Carefully remove mirror from unit by lifting it gently from the stove. Store in a safe place or lay it face down on the carpet. 2. From the bottom, lift up the log set ember bed and remove it from the unit (do not pull up on logs). 3. Remove spring clip from bulb. Hold socket and pull out old bulb. 4. Hold socket and push in new bulb. Replace spring clip. 5. Repeat steps 2 and 3 for the second bulb.
CLEANING AND MAINTENANCE Continued CLEANING FRONT PANEL GLASS WARNING: When cleaning unit, the power supply should be disconnected and the unit should be cool. Over time the front glass panel may become dirty or dusty. Dust can be removed by lightly rubbing the glass surface with a clean, lint free cloth or paper towel. To remove fingerprints or other marks, use a damp cloth with a good quality household glass cleaner.
TROUBLESHOOTING WARNING: Turn off appliance and let cool before servicing. Only a qualified service person should service and repair heater. OBSERVED PROBLEM POSSIBLE CAUSE REMEDY Stove turns off and will not turn on 1. Stove has overheated and safety devise has cause thermal switch to disconnect or home circuit breaker has opened 1. Reset switch by turning main power switch off and waiting 5 minutes then turning it back on Flame is not moving 1. Loose wiring 1.
NOTES _____________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ___________
NOTES _____________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ___________
WARRANTY INFORMATION KEEP THIS WARRANTY Model Serial No. Date Purchased Always specify model and serial numbers when communicating with the factory. We reserve the right to amend these specifications at any time without notice. The only warranty applicable is our standard written warranty. We make no other warranty, expressed or implied.