Owner Manual Unvented Gas Log Heater VF-30N-PJD, VF-30P-PJD VF-24N-PJD, VF-24P-PJD VF-18N-PJD, VF-18P-PJD

www.desatech.com
111826-04C18
10. Continue holding down metal core for
about 10 seconds and then release the metal
core. Pilot should stay lit. If not, repeat steps
one through 4, page 17.
11. Turn MAN knob to ON position - main gas
ows.
12. Turn Motor-knob to adjust ame. Knob has
a slipping clutch that allows manual ame
height adjustment.
TO TURN GAS OFF


Press OFF button on remote control to switch
off main gas and pilot gas or manually turn
Motor-Knob clockwise to the "O" OFF
position.

Press to decrease the ame height and shut off
main burner.
INSPECTING BURNERS
Check pilot ame pattern and burner ame pat-
terns often.

Figure 19 shows a correct pilot ame pattern.
Figure 20 shows an incorrect pilot ame pattern.
The incorrect pilot flame is not touching the
thermocouple. When the thermocouple cools, the
heater will shut down.
If pilot ame pattern is incorrect, as shown in
Figure 20
• turn heater off (see To Turn Off Gas to Appli-
ance, above or page 17)
• see Troubleshooting, page 20
Note: The pilot ame on natural gas units will
have a slight curve, but ame should be blue and
have no yellow or orange color.
OPERATING HEATER
Continued
Thermocouple
Thermocouple
Figure 20 - Incorrect Pilot Flame Pattern
(Natural Gas Pilot Shown)
Figure 19 - Correct Pilot Flame Pattern
(Natural Gas Pilot Shown)

Figure 21 shows correct burner ame pattern.





If burner ame pattern is incorrect, as shown in
Figure 22
• turn appliance off (see To Turn Off Gas to Ap-
pliance in column 1 or page 17
• see Troubleshooting, page 20
Figure 21 - Correct Burner Flame Pattern
Figure 22 - Correct Burner Flame Pattern
Yellow Tipping
at Top of Blue
Flame