Instructions / Assembly

ASSEMBLY and INSTALLATION
Tool Required: Screwdriver
For Type A: Center Nipple Attachment (see Fig. 1/Fig 2/Fig. 3)
1. Remove the switch housing cover from the fan by unscrewing the three screws.
2. Remove the threaded plug from the center of this cover by unscrewing it. You may discard
this piece or keep it for future use.
3. Attach the cover to fitter and feed the kit wires (black and white) through the hole of the cover.
Screw on the cover and secure it to the fitter. Be sure it is tight enough to prevent light kit
from vibrating loose.
4. Locate two single wires in switch housing. White (gray on some models) and blue (red on
some models) labeled “for light”.
5. Connect wires from ceiling fan to wires from light kits using wire nuts provided.
-White (gray) to white
-Blue (red) to black
For secure connection, put electrical tape around wire nuts.
6. Carefully push all wires back into switch housing of fan. Then replace the cover with original
screws.
7. Install 60 watt max. and glass globe or shade(s). Gently tighten three thumb screws provided.
Do not over tighten.
Some units may allow up to 100 watt max. bulb (not provided) on your single light kit.
8. Restore the power and your light kit is ready for operation
9. If light kit does not work, turn off the electricity and lower either the canopy or the decorative
housing of your ceiling fan to make sure the blue wire is connected to black supply wire.
Please refer to the electrical connections section of the ceiling fan instruction manual.