56621-BN Grayson LED 52'' Ceiling Fan Downrod Mount Only V 1.
SAFETY PRECAUTIONS 1. Turn off power at main electrical service box before starting installation 2. Electrical connections must comply with local code ordinances, national electrical codes, CEC, NEC and ANSI/NFPA 70. 3. Make sure the installation site you choose allows the fan blades to rotate freely without any obstructions. 4. When mounting the fan on a ceiling outlet box, Use an approved (CSA for Canada and UL for U.S.) ceiling fan box marked "FOR FAN SUPPORT".
ASSEMBLY DRAWING 8. LIGHT KIT WARNING: BE SURE TO TURN OFF POWER BEFORE INSTALLING - Install proper wattage and type of bulb identified on light kit or shade. - Place glass on light kit by turning clockwise firmly for securement. Motor Light Kit Glass Bulb Fig .10a WARNING: Ensure that all connections, set screws and screws are securely tightened before the next step. To clean the fixture, turn off the power, wait for it to cool, and wipe the fixture with a clean, soft cloth. 1. Wooden Joist 2.
INSTALLATION 1. A NOTE: All set screws must be checked and retightened where necessary , before and after installation. 6. MOUNTING OPTION - Place blade bracket screw through, fibre washer and blade. - Align with corresponding hole in blade bracket. - Repeat with (2) remaining screws and tighten. DOWNROD MOUNT Using a Philips screwdriver loosen the two upper jam screws on the yoke. Position downrod inside canopy. Route wires exiting yoke on motor through ceiling canopy and downrod.
4. 5. MOUNTING FAN ASSEMBLY - Place two screws and washers on mounting plate (marked B on diagram) which correspond with slots in canopy. Screw in two turns. - Position canopy to mounting plate aligning slots to screws (marked B on diagram) then turn to lock. - Position and tighten the two screws and washers (marked A on diagram) then tighten the two screws (marked B on diagram). INSTALL MOUNTING BRACKET 2.
3. A 3. ELECTRICAL HOOK-UP Fig.4 120 V SUPPLY CIRCUIT ELECTRICAL HOOK-UP B - Push all connected wires up into ceiling box. - Position the receiver into the canopy as shown direction. Fig.6a Reciever BLACK SUPPLY CIRCUIT 120V WHITE Mounting Plate BLUE ANTENNA WHITE BLACK BLUE BLACK WHITE Fan Fan In Quebec, the installation of this product must be carried out by a qualified electrician. Fig.