Installation Guide

Pg. #4
NOTE:
All set screws must be checked and
retightened where necessary , before and after
installation.
MOUNTING OPTION
INST
INST
ALLA
ALL
A
TION
TION
1.
DOWNROD MOUNT
-
Using a
Philips
sc
rewdriver loosen the
two
upper
jam
sc
r
ews
on
the
yoke.
-
Position down
rod inside canopy.
-
Route wir
es
exiting yoke on motor through ceiling canopy
and
down
r
od.
- Position down
r
od/canopy into
yoke and
align holes
in
yoke and
down
r
od.
- Inse
r
t bolt through
hole
in yoke and downrod.
Be
careful
not
to
damage
or
cut the fan wires.
- Tighten flat washer, lock washer, and nut and bolt (not included on
some
models
).
Secu
r
e
with cotter pin through hole in the end of the
bolt.
-
Secur
e
downrod in position by tightening upper
jam screws.
A
Pg. #9
MOUNT BLADE BRACKETS TO BLADES
6.
- Place blade bracket screw through, fibre washer and blade.
- Align with corresponding hole in blade bracket.
- Repeat with (2) remaining screws and tighten.
Blade
Bracket
Fibre Washer
Fig. 8
Blade Bracket Screw
- Insert the blade arm into the fan as shown.
- Tighten the blade arm to motor with the screw and lock washer as shown.
- Slightly turn the blade after installation and repeat the same step for the
other blades.
MOUNTING BLADES TO MOTOR
7.
a9.giF b9.giF
Bolt
Yoke
Jam
Screw
Cotter
Flat
Washer
Pin
Fig.2b
CAUTION
Do not loosen two
lower jam screws
Fig.2c