Installation Guide

Pg. #8
Pg. #5
INSTALL MOUNTING BRACKET
- Secure mounting bracket and rubber gaskets to outlet box.
2.
WARNING: To Reduce The Risk Of Fire, Electric Shock, Or Personal
Injury, Mount To UL/CSA Listed Outlet Box Marked Acceptable for
Fan Support And Use Mounting Screws Provided With The Outlet Box.
MOUNTING FAN ASSEMBLY
- Place two screws and washers on mounting plate (marked B on diagram)
which correspond with slots in canopy. Screw in two turns.
- Position canopy to mounting plate aligning slots to screws (marked B on
diagram) then turn to lock.
- Position and tighten the two screws and washers (marked A on diagram)
then tighten the two screws (marked B on diagram).
ENGAGE HEMISPHERE (Downrod Mount Only)
4.
5.
3
3
.
.
- Carefully rotate fan assembly until groove in hemisphere locks over tab of
canopy assembly.
NOTE: When installing fan on sloped ceiling, make sure tab on hanger bracket
faces towards the top of the slope. Depending on the slope, a longer
downrod may be required to prevent fan blades from hitting the ceiling.
WARNING: Failur
e to seat tab in g
roove could cause damage to
electrical wires and possible shock or fire hazard.
Downrod
Hemisphere
Groove
Fig.7b
- Hang fan on temporary hook or mounting bracket.
Fig.7a
(A)
(B)
(B)
Washers
(A)
Diagram Fig.3b is for Downrod Mount.
A
ELECTRICAL HOOK-UP
Make the following wire connections to the receiver unit (see fig. 4) using the
wire nuts supplied.
- connect GREEN fan wire to BARE (ground) wire.
- connect BLACK receiver unit wire to BLACK supply wire.
- connect WHITE receiver unit wire to WHITE supply wire.
- connect WHITE receiver unit wire (MOTOR N) to WHITE fan wire.
- connect BLACK receiver unit wire (MOTOR L) to BLACK fan wir
e.
- connect BLUE receiver unit wire (FOR LIGHT) to BLUE light wire.
-
-
After making the wire connections, ensure the wires should be spread
apart with the grounded conductor and the equipment-grounding
conductor on one side of the outlet box and the ungrounded conductor
on the other side of the outlet box.
Ensure the splices after being made should be turned upward and
pushed carefully up into the outlet box.
Ceiling
Outlet box Screws
(not provided)
Fig.3a
Canopy
Fig3b
Wood Joist
Outlet Box
Rubber Gasket
Mounting Bracket