Installation Guide

INSTALLATION INSTRUCTIONS
COMBINATION SLIDING DOOR PULL AND LOCK
2-5/16”
1-7/8”
Cut one simple notch in door
1
3
2
3
Slip pull into posion as shown.
Mark screw hole locaons on
door. Countersink to 5/16” dia.
2
Fasten side plates with wood
screws (B). Align center secon
by loosening and ghtening
machine screws (A).
A
B
1
Mark and morse strike on jamb
to correspond to lock posion on
door.
Drill 15/16” diameter hole 1/2”
deep in center of morse.
Screw strike plate into posion
using #6 x 5/8” large at head
wood screws
BE SURE FORK ARM ENGAGES ROCKER PIN
WHEN REVERSING PLATES
BEFORE CHANGING PLATES
WITH ONE PLATE REMOVED
AFTER CHANGING PLATES
When it is desirable to reverse outside plates on lock assembly, rst
remove machine screws on each side - change plates from side to side
(making sure that fork arm engages rocker pin) and re-assemble
Back out machine screw on
each side of 3/16” - then in-
stall per instrucons
INSTALLATION OF STRIKE PLATE FOR LOCKING SET ONLY
TO ASSEMBLE AFTER REVERSING PLATES FOR 1-3/4” THICK DOORS