Instructions / Assembly

SYRAH 3 LT VANITY LIGHT
ASSEMBLY/INSTALLATION INSTRUCTIONS
1. Before beginning the installation, carefully unpack and identify all parts. Be sure the
power to the installation point is OFF.
2. Using (2) JUNCTION BOX SCREWS, securely fasten the MOUNTING STRAP to
the JUNCTION BOX.
NOTE: This fixture also provided with 2 wood screws for optional channel shape
MOUNTING BRACKET installation. It will be necessary to mark the location of the
keyhole slots on the mounting surface and drill holes for fasteners. Use fasteners
suitable for the mounting surface. The narrow end of the KEYHOLE SLOTS should
face up. Fit the heads of the WOOD SCREWS through the KEYHOLE SLOTS in the
MOUNTING STRAP, pull down the MOUNTING STRAP until the WOOD SCREW
heads are seated at the small ends of the KEYHOLE SLOTS, and secure both
WOOD SCREWS.
3. MAKE THE CONNECTIONS: (We recommend (2) people for the remainder of
installation) Position the FIXTURE in front of the OUTLET BOX and pass the
FIXTURE SUPPLY and GROUND WIRES through the center of the NIPPLE.
Connect the HOUSE GROUND WIRE to the FIXTURE GROUND WIRE. Secure
both to the MOUNTING STRAP with GREEN GROUND SCREW. Using wire
Connectors, connect the HOUSE WHITE WIRE(S) to the FIXTURE WHITE(or
RIBBED) LEAD(S); Connect the HOUSE BLACK (or RED) WIRE to the
FIXTURE BLACK (or SMOOTH) LEAD(S). Wrap all connections with approved
electrical tape.
4. Place the BACK PLATE over the MOUNTING STRAP and secure it with (4) LOCK
SCREWS..
5. Locate the GLASS SHADES and pass over the SOCKETS, then thread SOCKET
RINGS onto end of the SOCKETS. Hand tighten until snug.
6. Install LIGHT BULB(s) (Sold separately) referring to fixture markings or labels for
maximum wattage.
7. Restore electrical power to installation point ON. Retain this sheet for future
reference.
#802413 (506493)
Customer Service: 1-800-558-8700
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.