Installation Guide

BRISTOL CHANDELIER & ISLAND LIGHT
ASSEMBLY/INSTALLATION INSTRUCTIONS
1. Before beginning the installation, carefully unpack and identify all parts. Be sure the power to
the installation point is OFF.
2. If SUPPORT ARMS on FIXTURE ASSEMBLY are collapsed when shipped, Carefully
separate ARMS by gently and evenly spreading them apart. See Figure 1.
3. Slide FIXTURE LOOP down along wires and thread securely onto NIPPLE located on top of
the FIXTURE BODY (Carefully pulling excess wire through FIXTURE LOOP).
4. Locate the CROSSBAR and secure to JUNCTION BOX with (2) JUNCTION BOX
SCREWS. Thread LOCK NUT A and VIBRATION PROOF WASHER A onto top end of the
NIPPLE. Thread the NIPPLE into the center of the CROSSBAR. Locate LOCK NUT B and
thread onto bottom end of NIPPLE. Tighten LOCK NUT A against CROSSBAR with pliers
until snug.
5. Locate the FIXTURE CHAIN and determine desired hanging height of fixture. Adjust chain
by removing links if needed. Please note that depending on chain material thickness, you
might be required to use chain pliers to spread links open (See Figure 2). Attach one end of
chain to FIXTURE LOOP, attached to top of fixture. Unravel FIXTURE WIRES and
GROUND WIRE and pass through FIXTURE CHAIN alternating links. Pass the fixture
wires through the following mounting components: CANOPY LOCK RING, CEILING
CANOPY, CANOPY CHAIN LOOP AND VIBRATION PROOF WASHER B.
6. MAKE CONNECTIONS:
(We recommend 2 people for the remainder of installation)
Position the FIXTURE under the JUNCTION BOX and pass the FIXTURE WIRES and
GROUND WIRES through the center of the NIPPLE. Connect the SUPPLY GROUND
WIRE to the FIXTURE GROUND WIRE. Secure both to the CROSSBAR with GREEN
GROUND SCREW. Using wire Connectors, connect the SUPPLY WHITE WIRE(S) to the
FIXTURE WHITE (or RIBBED) LEAD(S); Connect the SUPPLY BLACK (or RED) WIRE
to the FIXTURE BLACK (or SMOOTH) LEAD(S). Wrap all connections with approved
electrical tape.
7. With the connections properly made, carefully tuck all wires into JUNCTION BOX. Locate
the CANOPY CHAIN LOOP and thread onto the end of the NIPPLE. Proceed to thread
LOCK NUT B and VIBRATION PROOF WASHER B down NIPPLE and tighten against
CANOPY CHAIN LOOP. Pass the center hole in the CEILING CANOPY over the CANOPY
CHAIN LOOP and secure to ceiling by threading CANOPY LOCK RING onto CANOPY
CHAIN LOOP.
8. Locate the GLASS SHADES and pass over the SOCKETS, Thread SOCKET RINGS onto
end of the SOCKETS and hand tighten until snug.
9. Install the bulb(s) (Sold separately) referring to fixture labels for maximum wattage.
10. Restore electrical power to installation point. Retain this sheet for future reference.
Customer
Service:
1-800-558-8700
WIRE NUT
CROSS BAR
JUNCTION BOX SCREW
GREEN GROUND SCREW
NIPPLE
CANOPY CHAIN LOOP
CEILING CANOPY
LOCK NUT A
VIBRATION PROOF WASHER B
LOCK NUT B
VIBRATION PROOF
WASHER A
CANOPY LOCK RING
JUNCTION BOX
GROUND WIRE
SUPPLY WIRE
FIXTURE WIRE
Note:
This illustration is based on #510255, 504167 (5 Lights), the assembly/installation
instructions for #510321, 504175 (3 Lights), #504258, 517110 (2 Lights) and 512855, 517136
(9 lights) should be the same as #510255, 504167 (5 Lights).
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.