Instructions / Assembly

HYDE WALL MOUNT FIXTURES
ASSEMBLY/INSTALLATION
INSTRUCTIONS
NOTE: This fixture is suitable for up or down mounting.
1. Before beginning installation, carefully unpack and identify all parts referring
to Figure 1. Be sure the power to the installation point is OFF.
2. Using (2) JUNCTION BOX SCREWS, securely fasten the CROSSBAR to
the JUNCTION BOX.
3. MAKE CONNECTIONS:
(We recommend 2 people for the remainder of
installation) Position the FIXTURE in front of the JUNCTION BOX,
Connect the SUPPLY GROUND WIRE to the FIXTURE GROUND WIRE.
Secure both to the CROSSBAR with GREEN GROUND SCREW. Using
wire Connectors, connect the SUPPLY WHITE WIRE(S) to the FIXTURE
WHITE (or RIBBED) LEAD(S); Connect the SUPPLY BLACK (or RED)
WIRE to the FIXTURE BLACK (or SMOOTH) LEAD(S). Wrap all
connections with approved electrical tape.
4. Place the BACK PLATE over the CROSSBAR and secure it with (2) LOCK
NUTS.
5. Locate the GLASS SHADE(S) and pass over the SOCKET(S), Use SOCKET
RING WRENCH to thread SOCKET RING(S) onto end of the SOCKET(S)
and tighten.
6. Install the BULB(s) (sold separately) referring to fixture labels for maximum
wattage. The bulb quantities depend on the style (Refer to Figure 2)
7. Restore electrical power to installation point. Retain this sheet for future
reference.
Customer Service: 1-800-558-8700
FIGURE 1
FIGURE 2
#514612,514653 #514620,514661
#514638,514729 #514646,514737
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.