Installation Guide

TORINO WALL MOUNT & BATH LIGHT
ASSEMBLY/INSTALLATION INSTRUCTIONS
NOTE: This fixture is suitable for up or down mounting.
1. Before beginning the installation, carefully unpack and identify all parts referring
to Figure 1. Be sure the power to the installation point is OFF.
2. Using 2 JUNCTION BOX SCREWS, securely fasten the CROSSBAR to the
JUNCTION BOX.
3. MAKE THE CONNECTIONS: (We recommend 2 people for the remainder of
installation) Position the FIXTURE in front of the JUNCTION BOX and pass the
FIXTURE SUPPLY WIRES and GROUND WIRES through the center of the
NIPPLE. Using WIRE NUTS, Connect the SUPPLY GROUND WIRE to the
FIXTURE GROUND WIRE and then secure them to the CROSSBAR with
GREEN GROUND SCREW; Connect the SUPPLY WHITE WIRE(S) to the
FIXTURE WHITE(or RIBBED) LEAD(S); Connect the SUPPLY BLACK (or
RED) WIRE to the FIXTURE BLACK (or SMOOTH) LEAD(S). Wrap all
connections with approved electrical tape.
4. Place the BACK PLATE over the CROSSBAR and secure it with 2 LOCK NUTS.
5. Locate the GLASS SHADES and pass over the SOCKETS, Thread SOCKET
COLLARS onto end of the SOCKETS. Hand tighten until snug.
6. Install the BULB(s) (Sold separately) referring to fixture markings or labels for
maximum wattage. The bulb quantities depend on the style (Refer to Figure 2) you
purchased.
7. Restore electrical power to installation point ON. Retain this sheet for future
reference.
Customer Service: 1-800-558-8700
FIGURE 1
FIGURE 2
#514786 #514745 #514752
#514760 #514778
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.