Instructions / Assembly

DHI Item #: 516807.516823.516831.516849.
517144.507111.508416
1-LT MINI PENDANT
ASSEMBLY /INSTALLATION INSTRUCTIONS
1. Before beginning the installations,carefully
unpack and identify all parts.
2. Turn off power while installing or servicing
this fixture.
3. Thread the cord through the Canopy and Strain
Relief.
Measure the desired length of the cord ( A )
from the Canopy to the glass and leave additional
9" cord ( B ) above the Canopy ( include the
Canopy ). Then cut off the unnecessary cord
( See Fig 1. )
4. Adjust Strain Relief at 9" position from the top
of cord.
5. Mark the 3" cord ( C ) from the top of the cord.
( B ). Use a knife to peel off the insulation of the
cord ( C ) carefully to show the 3 inside wires
out.. ( See Fig 1 )
Caution : Cutting too deep may cut off three
inside wires and destroy the insulation
surface of the three inside wires.
6. Peel off the 3 wires from the top about 3/8" long
( D ) to expose the cooper wiring.
7. Mount Mounting Strap securely to Junction Box
with 2 Mounting Screws through slot in Mounting
Strap.
8. Make wire connections with Wire Connectors :
.---Connect White wire from the fixture to White wire from Junction Box
with a Wire Connector.
.---Connect Black wire from the fixture to Black wire fom Junction Box
with a Wire Connector.
.---Fasten Green Ground wires from Junction Box and fixture Ground wire
to Mounting Strap with Green Ground screw.
9. Tuck the wires carefully inside the Junction Box.
10. Pull the cord ( A ) down slightly until the Strain
Relief touches the Hex Nut. Attach the Canopy to
the Mounting Strap by using 2 screws.
11. Install the recommended bulb.
12. Turn off the power at fuse or Circuit Box. Customer Service : 1-800-558-8700
JUNCTION BOX
HOUSE GREEN
GROUND WIRE
WIRE CONNECTOR
CORD
GLASS SHADE
BULB
( SOLD SEPARATELY )
CANOPY SCREW
CANOPY
STRAIN RELIEF
MOUNTING
STRAP
FITTING
MOUNTING SCREW
GREEN GROUND SCREW
A
C(3")
D(
3
8
")
FIG.1
B( 9")
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.