Instructions / Assembly

ManualsBrandsDesign House ManualsLightingJerico 3-Light Oil Rubbed Bronze Rail Lighting with Frosted White Glass Shades

517151 517169 517177 517185

ASSEMBLY /INSTALLATION INSTRUCTIONS

1. Before beginning the installation,carefully unpack and identify

all parts.

2. Turn off power while installing or servicing this fixture.

3. Thread wires upward through fixture body tube. Pull the wires gently

in case the wires wind around in the tube.

4. Connect fixture body tube with rail by rotating the tube of fixture body.

5. Thread wires upward through extension tubes. Pull the wires gently in

case the wires wind around in the tube. Connect extension tubes with

fixture body tube by rotating the extension tubes.

6. Screw the swivels to tubes. Remember to make swivel notches secure

in correct position as shown in the diagram.

7. Thread wires through hole of canopy and canopy plate.

8. Insert swivel nipples into holes of canopy and plate,and fasten with washers

and nuts provided. Make sure the fixture ground wire has been been

assembled.

9. Attach the cross bar to the ceiling junction box with two mounting

screws.

10. Connect all Black fixture wires to Black wire provided with large wire connector &

Connect all White fixture wires to White wire provided with large wire connector.

11. Connect Black supply wire with Black fixture wire & White supply wire with White

fixture wire by using small wire connectors. Connect ground supply wire and

ground fixture wire to green ground screw on the cross bar.

Customer Service : 1-800-558-8700

IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,

CONSULT A LICENSED ELECTRICIAN.

WASHER

EXTENSION

TUBE

RAIL

GLASS

SHADE

NUT

CANOPY

PLATE

BALL FINIAL

FIXTURE

GROUND WIRE

SWIVEL NOTCH

FIXTURE BODY

TUBE

LAMP

HOLDER

SOCKET RING

GLASS SHADE

TIP

BULB

LAMP HOLDER

SUCTION

CUP

Summary of content (2 pages)

PAGE 1
FIXTURE GROUND WIRE WASHER SWIVEL NOTCH 517151 517169 517177 517185 ASSEMBLY /INSTALLATION INSTRUCTIONS EXTENSION TUBE NUT CANOPY CANOPY PLATE BALL FINIAL FIXTURE BODY RAIL TUBE 1. Before beginning the installation,carefully unpack and identify all parts. LAMP 2. Turn off power while installing or servicing this fixture. HOLDER 3. Thread wires upward through fixture body tube. Pull the wires gently in case the wires wind around in the tube. GLASS SHADE 4.
PAGE 2
12. Raise the fixture to the ceiling and secure in place with the ball finial 13. Attach the glass shade to the glass holder,secure it with socket ring. 14. Attach the suction cup to the top surface of the halogen bulb lens. 15. Insert the bulb into the socket and twist. 16. Remove the suction cup from the halogen bulb lens by pulling the tip of the suction cup. 17. Adjust the spot heads to a desired postion by moving the swivel. 18. Turn on the power at the main fuse or circuit breaker box.