Installation Guide

Pre-installation: Slide the fixture loop down along wires and
thread securely onto the nipple on top of the fixture assembly.
Use a pair of pliers to open end link of chain. Attach the end
of chain to the loop at the top of the fixture.
(minimum thickness 1-1/2 Inch)
5. Install the bulbs (not included ).
6. Once chain & wire are arranged, plug into outlet &
Fig.1
Fig.2
Fig.3
Note: Please consult a qualified electrician if you are
not certain of the installation.
Caution: Before starting the installation, disconnect the
power by turning off the circuit breaker or removing
the fuse at fuse box.
Note:Cut off the fixture copper ground wire.
A.For plaster or plaster board ceilings
1. Drill a hole in the ceiling to the same diameter as the
closed flaps of the enclosed toggle bolt assembly(A).
There are two options for you to install the lamp:
Option 1--Portable wire installation
Carefully unpack the fixture and lay out all
parts on a clear surface.
B.For wood or acoustic board ceilings
1. Select a place on the ceiling where a wood beam exists.
2. Thread the wood screw into hook(B).
2. Insert flaps and bolt into the ceiling with the toggle bolt
protruding through the ceiling and lock the assembly by
threading on the hook as shown.
3. Drape your chain to second hook or let it hang straight.
Option 2--Fixed wire installation
1. Carefully unpack the fixture and lay out all parts
on a clear surface.
3. Screw the assembly into the wood beam.
4. Drape your chain to second hook or let it hang straight.
turn on the switch and enjoy.
4. Use a pair of pliers to open end link of chain and attach
it to screw collar loop.
2. Cut off the plug and switch at point "A" with wire
cutters.
3. Attach mounting strap to outlet box using outlet
box screws.
nipple down in screw collar loop, tighten ring.
6. Connect the labeled wire unlabeled to black wire from
supply circuit. Connect the unlabeled wire to white wire
from the supply circuit. Cover the connections using the
wire connector provided. Tie the ground wire from the
5. Weave electrical wires and ground wire up chain,
through screw collar loop, and canopy. Unscre
w
ring from screw collar loop, slide the ring and then
the canopy over the chain.
#517565, 517664
Customer Service: 1-800-558-8700
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
MILLBRIDGE SWAG LIGHT
ASSEMBLY/INSTALLATION INSTREUCTION
8. Install light bulbs (sold seprately).
9. Restore electricity at main fuse or circuit breaker box.
fixture and from outlet box to ground screw on
the mounting strap.
7. Raise the canopy to the ceiling and screw the