Installation Guide

RIDGEWAY CHANDELIER LIGHT
ASSEMBLY/INSTALLATION INSTRUCTIONS
1. Before beginning the installation, carefully unpack and identify all parts. Be sure the
supply power is OFF.
2. If SUPPORT ARMS on FIXTURE ASSEMBLY are collapsed when shipped, Carefully
separate ARMS by gently and evenly spreading them apart. See Figure 1.
3. Slide CENTER POST down along wires and thread securely onto NIPPLE B which
located on top of the fixture body (Carefully pulling excess wire through FIXTURE
LOOP).
4. Locate the CROSSBAR and secure to JUNCTION BOX with (2) JUNCTION BOX
SCREWS. Thread LOCK NUT A and VIBRATION PROOF WASHER A on top end of the
NIPPLE. Thread the NIPPLE into the center of the CROSSBAR. Locate LOCK NUT B
and thread onto bottom end of NIPPLE. Tighten LOCK NUT A against CROSSBAR with
pliers until snug.
5. Locate the FIXTURE CHAIN and determine desired hanging height of fixture. Adjust
chain by removing links if needed. Please note that depending on chain material thickness,
you might be required to use chain pliers to spread links open (See Figure 2). Proceed to
attach one end of chain to FIXTURE LOOP, attached to top of fixture. Unravel FIXTURE
WIRES and GROUND WIRE and pass through FIXTURE CHAIN alternating links at
every 3 inches. Proceed to pull the fixture wires through the following mounting
components: 1) CANOPY LOCK RING, 2) CEILING CANOPY, 3) CANOPY CHAIN
LOOP, 4) VIBRATION PROOF WASHER B.
6. MAKE ELECTRICAL CONNECTIONS:
(We recommend 2 people for the remainder
of installation) Position the FIXTURE under the JUNCTION BOX and pass the FIXTURE
WIRES and GROUND WIRES through the center of the NIPPLE. Using wire Connectors,
Connect the HOUSE GROUND WIRE to the FIXTURE GROUND WIRE and secure to
the CROSSBAR with GREEN GROUND SCREW, Connect the HOUSE WHITE WIRE(S)
to the FIXTURE WHITE(or RIBBED) LEAD(S); Connect the HOUSE BLACK (or RED)
WIRE to the FIXTURE BLACK (or SMOOTH) LEAD(S). Wrap all connections with
approved electrical tape.
7. With the connections properly made, carefully tuck all wires into JUNCTION BOX.
Locate the CANOPY CHAIN LOOP and thread onto the end of the NIPPLE. Thread
LOCK NUT B and VIBRATION PROOF WASHER B down NIPPLE and tighten against
CANOPY CHAIN LOOP. Pull the center hole in the CEILING CANOPY over the
CANOPY CHAIN LOOP and secure to ceiling by threading CANOPY LOCK RING onto
CANOPY CHAIN LOOP.
8. Locate the GLASS SHADES and pull over the SOCKETS, Thread SOCKET RINGS onto
end of the SOCKETS and hand tighten until snug.
9. Install the bulb(s) (Sold separately) referring to fixture markings or labels for maximum
wattage.
10. Restore supply power (ON). Retain this sheet for future reference.
Customer Service:
1-800-558-8700
Note: This illustration is based on #519330, 519413 (3 Lights), the assembly/
installation instructions for #519322, 519405(5 Lights) is same as #519330, 519413
(3 Lights)
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.