Installation Sheet

TORINO TWO HANDLE KITCHEN FAUCET
Models 522110
Your new Design House faucet will give you years of trouble free performance. Thank you for
choosing our product for your home. Please read all of these instructions carefully before
installing your new faucet.
When installing your new faucet, hand tighten the connector nuts, then use one wrench to
anchor the fitting and a second wrench to tighten the nut one additional turn. Connections that are too tight will reduce the integrity of the system. Wrap threaded connections (except aerator thread in spout or where o-ring or rubber sealant
are present) with Teflon tape available from your local hardware or plumbing supply store.
Always wrap in a clockwise direction.
IMPORTANT POINTS
SAFETY TIPS
ALWAYS protect your eyes with safety glasses.
Helpful tools to install this faucet:
Teflon tape (2) crescent wrenches basin wrench
flashlight faucet supply tubes
silicon sealer
INSTALLATION PROCEDURE
1-800-558-8700
Mequon, WI 53092
Design House is a registered
brand of DHI Corp.
1.Shut off water supplies.
Remove old faucet.Insert the
handle assembly in the proper position. Assemble metal washer, mounting nut and locking screw
onto body underside of sink.
Firmly tighten the locking screws
to metal washer.
3.Position the bodies as in illustration
to install quick connects on hot and
cold inlets. Carefully bend the hoses
to fit available space.
Push the T-tube(B) onto the end of
the spout shank (A) until it seats. Then insert the clip(C) side 1 into groove 1 and its side 2 into groove 2.
Push clip until it slides into place. Make sure clip is riding on grooves
of T-tube not through it.
6.Make connections to water
lines.Use 1/2" I.P.S. faucet
connections (6A, not included) or use
supplied coupling nuts (6C) with 3/8"
O.D.ball-nose riser (6B, not included).
Use wrenches to tighten connections. Do not overtighten.
5.Insert spray hose down through
the support and sink. Attach the
spray hose to the connection
beneath the faucet by aligning
the tabs on quick connector.
Push quick connect housing
firmly upward and snap onto
receiving tube tab. Pull down moderately to ensure connection has been made.
4.For models with spray:
Mount spray support in far right
hole in sink. Screw hold - down nut onto shank and hand tighten.
2.Place the spout assembly in
position on sink. From under sink,
secure firmly to sink with rubber
washer, metal washer and nut.
C
B
A
side1
side2
groove1
groove2
3
21
6A
6B
6C
6
4
5