Installation Sheet

Your new Design House faucet will give you years of trouble free performance. Thank you for
choosing our product for your home. Please read all of these instructions carefully before
installing your new faucet.
When installing your new faucet, hand tighten the connector nuts, then use one wrench to
anchor the fitting and a second wrench to tighten the nut one additional turn. Connections that are too tight will reduce the integrity of the system.
Wrap threaded connections (except aerator thread in spout or where o-ring or rubber sealant
are present) with Teflon tape available from your local hardware or plumbing supply store.
Always wrap in a clockwise direction.
IMPORTANT POINTS
SAFETY TIPS
ALWAYS protect your eyes with safety glasses.
Helpful tools to install this faucet:
Teflon tape
(2) crescent wrenches
basin wrench
flashlight faucet supply tubes
silicon sealer
1a.Shut off water supply. Remove
old faucet.
Escutcheon Installation (optional).
Place gasket (1A) on bottom of
escutcheon. Place faucet through
mounting holes in sink. Secure
faucet to sink using washer (1B)
and nut (1C) provided.
1b.Flange Installation (optional).
Place Flange (1A) on bottom of
new faucet. Place faucet
through mounting holes in sink.
Secure faucet to sink using
washer (1B) and nut (1C)
provided.
2.Insert spray support through
far right-hand hole on sink.
Screw hold-down nut onto
shank and hand tighten.
4.Make connections to water
lines. Use 1/2" I.P.S. faucet
connections (4A, not included) or
use coupling nuts (4C, not
included) with 3/8" O.D.ball-nose
riser (4B, not included). Use
wrenches to tighten connections.
Do not overtighten.
3.Insert spray hose down
through support and sink.
Attach spray hose to spray
hose nipple underneath
faucet body.
5.Important: After installation is completed, remove aerator.
Turn on water supply and allow
both hot and cold water to run
for at least one minute each.
While water is running, check
for leaks. Replace aerator.
4A
4B
4C
1A
1B
1C
1C
1B
1A