Manualshelf

Use and Care Manual

ManualsBrandsDesign House ManualsKitchen ApplianceMontello 2-Handle Side Sprayer Kitchen Faucet in Satin Nickel
12
• ALWAYS protect your eyes with safety glasses.
SAFETY TIPS
IMPORTANT POINTS
Helpful tools to install this faucet:
•
basin wrench
•
Teflon tape
•
(2) crescent wrenches
•
silicon sealer
•
flashlight
•
faucet supply tubes
Models 524793, 524801, 524819
TWO HANDLE
KITCHEN FAUCET
Design House is a registered
brand of DHI Corp.
Mequon, WI 53092
1-800-558-8700
Your new Design House faucet will give you years of trouble free performance.
Thank you for choosing a Design House product for your home.
Please read all of these instructions carefully before installing your new faucet.
• When installing your new faucet, hand tighten the connector nuts, then use one wrench to anchor
the fitting and a second wrench to tighten the nut one additional turn. Connections that are too tight
will reduce the integrity of the system.
• Wrap all threaded connections (except aerator thread in spout) with Teflon tape available from your
local hardware or plumbing supply store. Always wrap in a counter-clockwise direction.
INSTALLATION PROCEDURE
1. Shut off water supplies.
Remove old faucet.
Insert the handle assembly in
the proper position.
Assemble metal washer,
mounting nut and locking
screw onto body underside of
sink.
Firmly tighten the locking
screws to metal washer.
2. Place the spout assembly in
position on sink.
From under sink, secure
firmly to sink with rubber
washer, metal washer and
nut.
3. Position the bodies as in
illustration to install quick
connects on hot and cold
inlets.
Carefully bend the hoses to fit
available space.
Push the T-tube(B) onto the
end of the spout shank (A)
until it seats. Then insert the
clip(C) side 1 into groove 1
and its side 2 into groove 2.
Push clip until it slides into
place. Make sure clip is riding
on
grooves of T-tube not
through it.
1 2 3
4. For models with spray:
Mount spray support in far
right hole in sink.
Screw hold-down nut onto
shank and hand tighten.
5. Insert spray hose down
through the support and sink.
Attach the spray hose to the
connection beneath the faucet
by aligning the tabs on quick
connector.
Push quick connect housing
firmly upward and snap onto
receiving tube tab.
Pull down moderately to
ensure connection has been
made.
6. Make connections to water
lines.
Use 1/2" I.P.S. faucet
connections (6A) or use
supplied coupling nuts (6C)
with 3/8" O.D.ball-nose riser
(6B).
Use wrenches to tighten
connections.
Do not overtighten.
4 5 6
6A
6B
6C
C
B
A
side1
side2
groove1
groove2

Summary of content (2 pages)