Installation Guide

ManualsBrandsDesign House ManualsKitchen ApplianceAberdeen 2-Handle Side Sprayer Kitchen Faucet in Polished Chrome

TROUBLE SHOOTING

Problem: Faucet leaks from under handle.

Cause: Bonnet is loose or o-ring on cartridge is

dirty or twisted.

Action:

1. Move handle to OFF position.

Unscrew the set screw on the side of the

handle seat.

Then remove the entire handle assembly.

2. Tighten the bonnet by turning it clockwise.

Move the cartridge stem to the ON position.

The leak should stop around the cartridge

stem.

3. If the leak does not stop, shut off the water

supply.

Remove the bonnet by turning it counter

clockwise.

Lift out the cartridge valve. Inspect the o-rings.

Clear debris, untwist, or replace if necessary.

Lift out the cartridge valve. Inspect the o-rings.

Clear debris, untwist, or replace if necessary.

4. Replace the cartridge making sure the wings

fit well into the cuts in the faucet body.

Tightly screw the bonnet onto the faucet body.

5. Reinstall the handle.

Problem: Faucet leaks around aerator or an

improper flow pattern.

Cause: Aerator is incorrectly fitted or is dirty.

Action:

1. Unscrew the aerator. Make sure all internal

parts are laying flat.

2. If there is debris, gently flush all parts inside.

3. Reinstall aerator.

Many of these parts come preassembled.

This exploded diagram is to assist in trouble

shooting.

MAINTENANCE

Under the Safe Drinking Water Act, the U.S. Environmental Protection Agency restricts the

amount of lead used in brass and solder. Your new faucet is made in strict compliance with

all government standards. The materials used in the manufacture of this faucet are of industry

standard quality and are similar to other plumbing products having brass fittings.

To reduce the amount of lead in your drinking water, allow the water to run for a moment before

filling your glass and remember to always use cold water for drinking purposes.

CONSUMER PROTECTION WARNING

Your new Design House faucet is designed to give you years of trouble free performance. Keep it

looking new by cleaning it periodically with a soft cloth. Avoid abrasive cleaners, steel wool and harsh

chemicals that will dull the finish and void your warranty.

Brass finishes are polished, then protected with a lacquer coating to help prevent tarnishing. Clean

these surfaces only with a damp, soft cloth.

POP-UP INSTALLATION

EXPLODED PARTS

Handle Seat

Disc Spring

Disc

Washer

Cartridge

Bonnet

Handle

Set Scew