Installation Guide

ManualsBrandsDesign House ManualsBathBarcelona Single-Handle 1-Spray Tub and Shower Faucet in Brushed Bronze

ALWAYS protect your eyes with safety glasses.

SAFETY TIPS

Wrap all threaded connections (except aerator thread in spout) with Teflon tape available from

your local hardware or plumbing supply store. Always wrap in a counter-clockwise direction.

When installing your new faucet, hand tighten the connector nuts, then use one wrench to

anchor the fitting and a second wrench to tighten the nut one additional turn. Connections that

are too tight will reduce the integrity of the system.

IMPORTANT POINTS

Helpful tools to install this faucet:

Your new Design House faucet will give you years of trouble free performance. Thank you for

choosing our product for your home. Please read all of these instructions carefully before

installing your new faucet.

(2) crescent wrenches

Teflon tape

basin wrench

faucet supply tubes

flashlight

silicon sealer

Models 524975,525592

SINGLE HANDLE

TUB&SHOWER FAUCET

Design House is a registered

brand of DHI Corp.

Mequon, WI 53092

1-800-558-8700

Summary of content (4 pages)

PAGE 1
Design House is a registered brand of DHI Corp. Mequon, WI 53092 1-800-558-8700 SINGLE HANDLE TUB&SHOWER FAUCET Models 524975,525592 Your new Design House faucet will give you years of trouble free performance. Thank you for choosing our product for your home. Please read all of these instructions carefully before installing your new faucet.
PAGE 2
INSTALLATION PROCEDURE 1.SHUT OFF WATER SUPPLY. Verify that the hole sizes and positions of holes in the wall are correct. Recommended component measurements. A.Shower and / or spout outlet hole: 1-1/4" diameter. B.Valve access hole: 6 inch diameter. C. Recommended valve depth to finished wall: 2" min. to 2-1/2"max. Be sure that the black template plate's surface is flush with the finished exterior surface of the wall. Be sure to position the valve body correctly in wall. "UP" marking up.
PAGE 3
INSTALLATION PROCEDURE 6 8 7 9 8E 8A 8C 8B colder hotter rotational limit stop stop on cartridge 8D 6.Before installing escutcheon, remove the plastic cap from plaster guard by twisting cap in a clockwise direction. Remove the screw from the inverter. 7.Place handle on valve stem and turn handle to full on mixed position. Turn on hot and cold water lines to full open for one minute each. Check for leakage. Shut off water at faucet. Remove the handle. 8.
PAGE 4
TROUBLE SHOOTING Problem: Leaks underneath handle. Cause: Bonnet has come loose or cartridge is dirty or broken. Action: Remove handle. Tighten the bonnet. If Water still does not completely shut off. Turn off water supply or turn off stop valves. Replace cartridge. Stop Valve Cartridge Bonnet MAINTENANCE Your new Design House faucet is designed to give you years of trouble free performance. Keep it looking new by cleaning it periodically with a soft cloth.