Instructions / Assembly

Step 3
Using the wood glue, squeeze a small bead of glue in all grooves before
assembling the cabinet sides, bottom, top and back panels. Be careful
not to use too much glue, this could cause access glue to squeeze out
and onto the panels, if this should happen, be sure to remove quickly.
Step 4
Slide the left and right side panels into the Left grooves of the
face frame, and mount the male clip to the face frame with a
screwdriver. Each male clip will need 2 Small screws (l).
Left Side
Right
Step 5
Slide the top(T) and bottom panel(B) into the grooves of the right and left side
panels, and then into the groove in the frame below until it is fully seated.
T
B
The two optional hanging bars are included. These are to be
installed at the top and bottom of the inside of the cabinet prior
to mount to the wall. The Larger screws(M 2 3/8'') are needed.
-3-