Instructions / Assembly

ManualsBrandsDesign House ManualsKitchenBrookings Ready to Assemble 30 in. x 21 in. x 12 in. Shaker Style Kitchen Bridge Wall Cabinet 2-Door in Espresso

ASSEMBLY INSTRUCTIONS

Wall Cabinets

562124, 562132, 562140, 562157, 562165, 562173, 562181, 562199, 562207, 562215, 562223, 562231

562249, 562256, 562264, 562272, 562282, 562298, 562306, 562314, 562322, 562330, 562348, 562355

561530, 561548, 561555, 561563, 561571, 561589, 561597, 561605, 561613, 561621, 561639, 561647

561654, 561662, 561670, 561688, 561696, 561704, 561712, 561720, 561738,561746, 561753, 561761

562546,562553

-1-

Summary of content (4 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS Wall Cabinets 562124, 562132, 562140, 562157, 562165, 562173, 562181, 562199, 562207, 562215, 562223, 562231 562249, 562256, 562264, 562272, 562282, 562298, 562306, 562314, 562322, 562330, 562348, 562355 561530, 561548, 561555, 561563, 561571, 561589, 561597, 561605, 561613, 561621, 561639, 561647 561654, 561662, 561670, 561688, 561696, 561704, 561712, 561720, 561738,561746, 561753, 561761 562546,562553 -1-
PAGE 2
Unpacking Precautions If using a sharp object to unpack the cabinet components and the packing materials, be careful to avoid scratching or damaging the cabinet components. The various packing materials may be used to protect the cabinet components during assembly. During the unpacking process, place the various components away from and to the side of the work area so that they will not be inadvertently knocked over or otherwise damaged.
PAGE 3
Step 3 Using the wood glue, squeeze a small bead of glue in all grooves before assembling the cabinet sides, bottom, top and back panels. Be careful not to use too much glue, this could cause access glue to squeeze out and onto the panels, if this should happen, be sure to remove quickly. Step 4 Slide the left and right side panels into the Left grooves of the face frame, and mount the male clip to the face frame with a screwdriver. Each male clip will need 2 Small screws (l).
PAGE 4
Step 6 Insert the Back panel between the two Side Panels. Step 7 Use the long screws(K), and the pre-drilled holes , to attach the back panel to the edges of the bottom panel. Step 8 Put the shelf pins on the left and right side panels using the holes provided. Be sure the pegs on the right & left are in the same position on each side to insure a level fit.