Instructions / Assembly

ManualsBrandsDesign House ManualsPlumbing Product2-Handle Laundry Faucet in Rough Brass and Chrome

Your new Design House faucet will give you years of trouble free performance. Thank you for

choosing our product for your home. Please read all of these instructions carefully before

installing your new faucet.

When installing your new faucet, hand tighten the connector nuts, then use one wrench to

anchor the fitting and a second wrench to tighten the nut one additional turn. Connections that

are too tight will reduce the integrity of the system.

Wrap threaded connections (except aerator thread in spout or where o-ring or rubber sealant

are present) with Teflon tape available from your local hardware or plumbing supply store.

Always wrap in a clockwise direction.

IMPORTANT POINTS

SAFETY TIPS

ALWAYS protect your eyes with safety glasses.

Helpful tools to install this faucet:

Teflon tape

(2) crescent wrenches

basin wrench

flashlight

faucet supply tubes

silicon sealer

1. Shut off water supplies.

Remove the old faucet. Position

the faucet body (1A) on laundry

tub (1B) and tighten the holding

screw (1C).

2. Attach the hot and cold

water lines.

3. IMPORTANT: After installation

is complete, remove the aerator to

flush the water lines. Do not lose

the gasket (3A) in the aerator. Turn

on the water supply and allow both

hot and cold water to run for at

least one minute each. This

flushes away any debris that could

cause damage to internal parts.

While the water is running, check

for leaks. Turn off the water and

replace the aerator.

Brass finishes are polished, then protected with a lacquer coating to help prevent tarnishing. Clean these

surfaces only with a damp, soft cloth.

Your new Design House faucet is designed to give you years of trouble free performance. Avoid abrasive

cleaners, steel wool and harsh chemicals that will dull the finish and void your warranty.

CONSUMER PROTECTION WARNING

To reduce the amount of lead in your drinking water, allow the water to run for a moment before

filling your glass and remember to always use cold water for drinking purposes.

Under the Safe Drinking Water Act, the U.S. Environmental Protection Agency restricts the

amount of lead used in brass and solder. Your new faucet is made in strict compliance with

all government standards. The materials used in the manufacture of this faucet are of industry

standard quality and are similar to other plumbing products having brass fittings.

Keep it looking like new by cleaning it periodically with a mild solution of soapy water. Rinse thoroughly and

then dry with a soft cloth.

HOT

COLD

Summary of content (2 pages)

PAGE 1
. Shut off water supplies. Remove the old faucet. Position the faucet body (1A) on laundry tub (1B) and tighten the holding screw (1C). 2. Attach the hot and cold water lines. 3. IMPORTANT: After installation is complete, remove the aerator to flush the water lines. Do not lose the gasket (3A) in the aerator. Turn on the water supply and allow both hot and cold water to run for at least one minute each. This flushes away any debris that could cause damage to internal parts.
PAGE 2
o 545749 - Rough Brass Problem: Faucet leaks from under handle. Cause: Bonnet is loose or o-ring on cartridge is dirty or twisted. Action: 1. Move handle to OFF position. Unscrew the screw on handle, then remove the handle. 2.Tighten the bonnet by turning it clockwise. Move the cartridge stem to the ON position. The leak should stop around the cartridge stem. 3. If the leak does not stop, shut off the water supply. Remove the bonnet by turning it counter-clockwise.