Installation Guide

o 545970 - Polished Chrome (with ABS Pop-Up)
o 545954 - Polished Chrome (without Pop-Up)
3
2
1
2
4
4
3
1
3. Remove the pivot nut (1). Install the
horizontal rod (2) and stopper (3), as
shown (4). Hand tighten the pivot nut (1).
Attach the horizontal rod (2) to the strap (5)
using the clip (6).
4. Insert the lift rod (1) through the faucet
assembly (2) and into the strap (3).
Tighten the screw (4).
1. Remove the stopper (1) and flange (2). Screw the
nut (3) all the way down, and push the gasket (4) down.
Problem: Faucet leaks from under handle.
Cause: Bonnet is loose or o-ring on cartridge is
dirty or twisted.
Action:
1. Move handle to OFF position. Remove the index
and unscrew the screw on handle, then remove the
handle.
2.Tighten the bonnet by turning it clockwise. Move
the cartridge stem to the ON position. The leak
should stop around the cartridge stem.
3. If the leak does not stop, shut off the water supply.
Remove the bonnet by turning it counter-clockwise.
Lift cartridge off body and remove cartridge seal.
Clean cartridge ports and cartridge seal. Place
cartridge seal into cartridge ports or replace if
necessary.
4. Replace the cartridge making sure the wings fit
well into the cuts in the faucet body. Tightly screw
the bonnet onto the faucet body.
5. Reinstall the handle.
Problem: Faucet leaks around aerator or an improper
flow pattern.
Cause: Aerator is incorrectly fitted or is dirty.
Action:
1. Unscrew the aerator. Make sure all internal parts
are laying flat.
2. If there is debris, gently flush all parts inside.
3. Reinstall the aerator.
1
5
6
3
Stopper
Flange
Horizontal rod
Screw
4
3
4
1
Clip
Pop-up body
Pivot nut
2
Strap
Gasket
Nut
Many of these parts come preassembled.
This exploded diagram is to assist in trouble
shooting.
2. Apply silicone to the underside of the flange (1).
Insert the pop-up body (2) into the sink. Screw the
flange (1) onto the pop-up body (2). The pivot
hole (3) must face the back of the sink. Use the
groove joint pliers to tighten the nut (4), but do
not over tighten. Do not turn the pop-up body (2)
while tightening the nut (4) or the sealant may
not seal properly. Clean away any excess putty.
2
Index
Screw
Handle
Washer
Cartridge
Bonnet
Coupling nut
Mounting nut
Aerator
Disc
Disc spring
Cap
(For 545954)
Lift rod &
Lift rod knob
(For 545970)