Installation Guide

o 545947 - Polished Chrome
o 545962 - Satin Nickel
3
2
1
2
4
4
3
1
3. Remove the pivot nut (1). Install the
horizontal rod (2) and stopper (3), as
shown (4). Hand tighten the pivot nut (1).
Attach the horizontal rod (2) to the strap (5)
using the clip (6).
4. Insert the lift rod (1) through the faucet
assembly (2) and into the strap (3).
Tighten the screw (4).
1. Remove the stopper (1) and flange (2). Screw the
nut (3) all the way down, and push the gasket (4) down.
Problem: Faucet leaks from under handle.
Cause: Adjusting ring or cap assembly has loosened.
Action:
1. Move the handle to OFF position. Remove the
index, unscrew the screw and remove the handle.
Unscrew the set screw, remove the connector.
2. Tighten the adjusting ring by turning it clockwise
with a small screwdriver. Move the ball stem to the
on position and continually tighten the adjusting ring
until the leak stops draining out from around the ball
stem.
3. If the leak does not stop, loosen the adjusting ring
and tighten the entire cap assembly by turning it
clockwise. Re-tighten the adjusting ring as before.
4 . Reinstall the handle.
Problem: Faucet leaks around aerator or an improper
flow pattern.
Cause: Aerator is incorrectly fitted or is dirty.
Action:
1. Unscrew the aerator. Make sure all internal parts
are laying flat.
2. If there is debris, gently flush all parts inside.
3. Reinstall the aerator.
1
5
6
3
Stopper
Flange
Horizontal rod
Screw
4
3
4
1
Clip
Pop-up body
Pivot nut
2
Strap
Gasket
Nut
Many of these parts come preassembled.
This exploded diagram is to assist in trouble
shooting.
2. Apply silicone to the underside of the flange (1).
Insert the pop-up body (2) into the sink. Screw the
flange (1) onto the pop-up body (2). The pivot
hole (3) must face the back of the sink. Use the
groove joint pliers to tighten the nut (4), but do
not over tighten. Do not turn the pop-up body (2)
while tightening the nut (4) or the sealant may
not seal properly. Clean away any excess putty.
2
Adjusting ring
Cap
Index
Screw
Handle
Connector
Set screw
Coupling nut
Washer
Nut
Disc spring
Disc
Mixer ball
Cam
Cam packing
Aerator