Installation Guide

Your new Design House faucet will give you years of trouble free performance. Thank you for
choosing our product for your home. Please read all of these instructions carefully before
installing your new faucet.
When installing your new faucet, hand tighten the connector nuts, then use one wrench to
anchor the fitting and a second wrench to tighten the nut one additional turn. Connections that are too tight will reduce the integrity of the system.
Wrap threaded connections (except aerator thread in spout or where o-ring or rubber sealant
are present) with Teflon tape available from your local hardware or plumbing supply store.
Always wrap in a clockwise direction.
IMPORTANT POINTS
SAFETY TIPS
ALWAYS protect your eyes with safety glasses.
Helpful tools to install this faucet:
Teflon tape
(2) crescent wrenches
basin wrench
flashlight faucet supply tubes
silicon sealer
2. Installing the tub spout
Install tub spout. Thread spout onto threaded
connection clockwise until the spout becomes
flush with the finished wall.
Thread sealant may be required depending on
your installation method. All thread sealants may
be found at your local hardware store.
3. Removing the plastic cap
Before installing the escutcheon, remove the
plastic cap (1) from the valve body (2) by
twisting the cap in a clockwise direction
when the depth distance (which is measured
from the center of the shower outlet to the finished wall surface) is 1-1/2 in. to 2-1/2 in..
4. Flushing the water outlets and checking for
leaks
Place the handle (1) on the valve body (2)
inverter and turn the handle (1) to the full on
mixed position. Turn on the hot and cold water
supply lines and allow the water to flow from the
outlets for one minute, or until all foreign matter
has been flushed out. Check for leaks. Shut off
the water at the faucet and supply lines. Remove the handle (1).
1. Installing the shower arm
Insert the long end of the shower arm (1)
through the shower flange (2), and wrap thread
sealant tape (not included) around the long end
of the shower arm (1) in a clockwise direction, as shown. Install the long end of the shower arm
(1) into the pipe elbow inside the wall. Carefully
tighten the shower arm (1) with a clean strap
wrench. Do not over tighten. Wrap thread
sealant tape around the pipe threads of the tub spout outlet (3, not included) in a clockwise
direction, as shown. Connect the tub spout outlet pipe (the tub spout outlet pipe should
project 4 in. to 4-5/32 in. from the finished wall)
to the lower pipe elbow (4, not included).
Tighten the elbow and tub spout outlet pipe
connections with a strap wrench.
2
3
4
2
5. Install escutcheon (1) onto valve and then
insert screws (3) to attach to valve body. Place
handle assembly (4) onto the valve and secure
with set screw (5).
6. Installing the shower head
Attach the shower head (1) to the shower arm
(2). Carefully tighten the shower head (1) with a
clean strap wrench.
1
4 in. to 4-5/32 in.
Wall
1
2
1
3
4
5
1
2