Installation Sheet

Notes:The picture in this installation instruction is for reference
only, pls refer to actual product in installation process.
2.
3.
2
3
with
with
4.
4
5.
5.
Apply plumbers putty to the
underside of the flange (1).Insert
the pop-up body(2) into the sink.
Screw the flange(1) onto the pop
-up body(2). The pivot hole (3)
must face the back of the sink.
Use the groove joint pliers to
tighten the nut(4), but do not over
tighten.Do not turn the pop-up
body(2) while tightening the nut
(4) or the sealant may not seal
property. Clean away any excess
putty.
a
t
off the hot and cold water line