Installation Guide

EASPORT PENDANT STEM (Item #570911)
ASSEMBLY/INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions, as you may need them at a later date.
CAUTION
Turn off the main power at the circuit breaker before installing the fixture, in order to prevent
possible shock
GENERAL
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)
standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a
qualified electrician. Remove the fixture and the mounting package from the box and make sure that
no parts are missing by referencing the illustrations on the installation instructions.
ASSEMBLY AND INSTALLATION (Shown with shade and glass lens; both sold separately)
Turn off the power at fuse or circuit breaker
1. Gently take all parts out of the package, lay them on a smooth surface and unscrew the WIRE
NUT. Attach MOUNTING BAR to the OUTLET BOX using (2) MOUNTING SCREWS.
2. Use a screwdriver to attach the EXTENSION TUBE into the COUPLING using the LOCKING
SCREW.
3. Thread the HEX NUTS onto the NIPPLE PIPE, leaving approximately 6.5” (160mm) between
HEX NUT A and HEX NUT B. Screw the NIPPLE into the COUPLING.
4. Make wire connections with WIRE NUTS:
A-Connect the black wire from the Fixture to the black supply wires.
B-Connect the white wire from the Fixture to the white supply wires.
C-Attach the fixture ground wire to the CROSS BAR with the green screw. Then connect it to
the supply GREEN GROUND WIRE with the WIRE NUTS. Carefully tuck wires back into the
OUTLET BOX.
5. Attach the CANOPY over the OUTLET BOX and tighten the NUT on to the FIXTURE
SCREWS.
6. Install BULBS with TYPE A MAX. 60W wattage (not included).
7. Place METAL WASHER at the center hole of FABRIC SHADE (Sold separately) and the GLASS
LENS (Sold separately) over the NIPPLE. Thread PLASTIC WASHER, METAL WASHER, HEX
NUT C, CAP and the LOCKING BALL over the NIPPLE. Tighten the LOCKING BALL.
Turn on the power at fuse or circuit breaker.
Customer Service: 1-800-558-8700
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.