Installation Guide

OTERO 3LT DIRECT TRACK BN SKU#577817
ASSEMBLY / INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions, as you may need them at a later date.
CAUTION
Turn off the main power at the circuit breaker before installing the fixture, in order to prevent possible shock.
GENERAL
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.) standards.
If you are unfamiliar with proper electrical wiring connections obtain the services of a qualified
electrician. Remove the fixture and the mounting package from the box and make sure that no
parts are missing by referencing the illustrations on the installation instructions. Tools are
required when install this fixture.
REQUIRED TOOLS
Philips screwdriver, electric drill,
ASSEMBLY AND INSTALLATION
Turn off the power at fuse or circuit breaker
1. Carefully unpack the fixture; lay out all parts on a clean surface.
2. Drill a hole in the wall to the same diameter as the hole of MOUNTING PLATE and insert the PLASTIC PLUGS
into the wall. Fasten the MOUNTING PLATE over the OUTLET BOX. Then screw the SELF THREADING SCREWS
into the PLASTIC PLUGS to secure the MOUNTING PLATE.
3. Tie ground wire from OUTLET BOX and from fixture to the GROUND SCREW on the MOUNTING PLATE.
Connect white wire from fixture to white wire (neutral wire) from supply circuit. Connect black wire from
fixture to black wire (live wire) from supply circuit. Cover connections using provided WIRE CONNECTORS
4. Attach the WALL PLATE to the OUTLET BOX by pulling the MOUNTING SCREWS all the way
through the WALL PLATE; thread the 2 LOCK NUTS to the MOUNTING SCREWS until the WALL PLATE
is firmly held against wall.
5. Adjust the SHADES to desired position.
Turn on the power at fuse or circuit breaker.
Customer Service: 1-800-558-8700
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
ITEM#577817