Instructions / Assembly

DOVE CREEK 1LT WALL MOUNT

ASSEMBLY/INSTALLATION INSTRUCTIONS

Please read carefully and save these instructions, as you may need them at a later date.

CAUTION

All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)

standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a

qualified electrician.

Remove the fixture and the mounting package from the box and make sure that no parts are

missing by referencing the illustrations on the installation instructions.

ASSEMBLY AND INSTALLATION

GENERAL

TOOLS REQUIRED

Turn off the main power at the circuit breaker before installing the fixture, in order to prevent

possible shock.

Philips Screwdriver.

Turn off the power at fuse or circuit breaker.

1. Before beginning the installation, carefully unpack and identify all parts.

2. Using (2) JUNCTION BOX SCREWS, securely fasten the CROSSBAR to the

JUNCTION BOX.

3. MAKE THE CONNECTIONS: Attach the FIXTURE GROUND WIRE to the

CROSS BAR with GREEN GROUND SCREW. Then connect it to the SUPPLY

GROUND WIRE with a wire nut. Using WIRE NUTS, connect the SUPPLY

WHITE WIRE(S) to the FIXTURE WHITE (or RIBBED) LEAD(S); Connect the

SUPPLY BLACK (or RED) WIRE to the FIXTURE BLACK (or SMOOTH)

LEAD(S). Wrap all connections with approved electrical tape.

4. Place the WALL PLATE over the CROSS BAR and secure it with (2) LOCKING

BALLS.

5. Locate the GLASS SHADE and slide it over the SOCKET. Thread the SOCKET

RING onto the end of the SOCKET. Hand tighten until snug.

6. Install LIGHT BULB (Sold separately). Use 1 x 60W watt Max (Medium base)

bulb or energy saving equivalent. DO NOT exceed the maximum wattage.

Turn on the power at fuse or circuit breaker.

Customer Service: 1-800-558-8700

IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,

CONSULT A LICENSED ELECTRICIAN.

#577981

PAGE 1
DOVE CREEK 1LT WALL MOUNT ASSEMBLY/INSTALLATION INSTRUCTIONS Please read carefully and save these instructions, as you may need them at a later date. CAUTION Turn off the main power at the circuit breaker before installing the fixture, in order to prevent possible shock. GENERAL All electrical connections must be in accordance with local and National Electrical Code (N.E.C.) standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a qualified electrician.