Instructions / Assembly

IMPALA 1LT WALL MOUNT & 3LT VANITY LIGHT
ASSEMBLY/INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions, as you may need them at a later date.
CAUTION
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)
standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a
qualified electrician.
Remove the fixture and the mounting package from the box and make sure that no parts are
missing by referencing the illustrations on the installation instructions.
ASSEMBLY AND INSTALLATION
Turn
off
the
power
at
fuse
or
circuit
breaker
.
GENERAL
TOOLS REQUIRED
Turn off the main power at the circuit breaker before installing the fixture, in order to prevent
possible shock.
Philips Screwdriver.
Turn
off
the
power
at
fuse
or
circuit
breaker
.
1. Before beginning the installation, carefully unpack and identify all parts.
2. Using (2) JUNCTION BOX SCREWS, securely fasten the CROSSBAR to the
JUNCTION BOX.
3. MAKE THE CONNECTIONS: Attach the FIXTURE GROUND WIRE to the
CROSS BAR with GREEN GROUND SCREW. Then connect it to the SUPPLY
GROUND WIRE with a wire nut. Using WIRE NUTS, connect the SUPPLY
WHITE WIRE(S) to the FIXTURE WHITE (or RIBBED) LEAD(S); Connect the
SUPPLY BLACK (or RED) WIRE to the FIXTURE BLACK (or SMOOTH)
LEAD(S). Wrap all connections with approved electrical tape.
4. Place the WALL PLATE over the CROSS BAR and secure it with (2) LOCKING
BALLS.
5. Put INNER GLASS shade(s) into OUTER GLASS shade(s) carefully and slide
over the SOCKET(S). Thread SOCKET RING(S) onto the end of the
SOCKET(S). Hand tighten until snug.
6. Install LIGHT BULB(S) (Sold separately), refer to fixture labels for max wattage.
The bulb quantities depend on the style (Refer to Figure 2). DO NOT exceed the
maximum wattage.
Turn on the power at fuse or circuit breaker.
Customer Service: 1-800-558-8700
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
#578153 #578161