Installation Guide

BRANSON OUTDOOR WALL LIGHT
ASSEMBLY/INSTALLATION INSTRUCTIONS
Item # 588608-BLK
Please read carefully and save these instructions, as you may need them for a
later date.
CAUTION
WARNING: For fixtures labeled for outdoor and wet location use, provide
a water-tight seal between the fixture and the wall surface by using
silicone or similar caulking. Turn off the main power at the breaker before
installing or service the fixture.
GENERAL
All electrical connections must be in accordance with local and National
Electrical Code (N.E.C) standards. If you are unfamiliar with proper
electrical wiring connections obtain the services of a qualified electrician.
Remove the fixture and mounting package from the box and make sure that
no parts are missing by referencing the illustrations on the installation
instructions.
TOOLS REQUIRED
Phillips screwdriver
ASSEMBLY AND INSTALLATION
1. Carefully unpack and identify all parts referring to the illustration.
2. Attach the CROSS BAR (C) to the OUTLET BOX (A) with the OUTLET BOX
SCREWS (D).
3. Pull out the outlet wires and the house grounding wire from the outlet.
4. Put the glass(I) inside the frames(H), press the buckle tightly onto the glass.
.
5.Make wire connections with WIRE NUTS (B).
--connect the black fixture wire to live supply wire.
--connect the white fixture wire to neutral supply wire.
--connect the fixture ground wire to the supply ground wire or attach the
fixture ground wire to the cross bar with the green screw, then attach to the
supply ground wire.
6. Carefully tuck the wires and WIRE NUTS (B) into the OUTLET BOX(A).
7.Unscrew the Ball NUTS(G) and PLASTIC WASHERS(F) from BACK
PLATE(E) then attach BACK PLATE to the wall going through OUTLET BOX
with screws and fasten PLASTIC WASHERS(F) and BALL NUTS(G).
8. Install the bulb (not included) into the head of the light, see wattage label at
socket area or packaging for maximum allowed wattage.
9. To prevent moisture from entering the outlet box and the fixtures back plate
causing a short, apply a bead of clear caulking to outline the outside of the
fixtures back plate where it meets the wall. Leave a small space at the
bottom to allow any condensation or moisture to escape.
10. Turn on the power at the main fuse or circuit breaker box.
IF IN DOUBT ABOUT ELECTRICAL
INSTALLATION, CONSULT A LICENSED
ELECTRICIAN.
Customer Service: 1-800-558-8700