Deck Tile lnstallation Guide Rev - 2/14/23 Design House • 262.518.1877 • www.todaysdesignhouse.
Deck Tile Installation Guide TABLE OF CONTENTS Table of Contents 02 lmportant Note 03 Introduction 04 Installation 05-06 Cutting Deck Tile 07-09 Fascia/Trim Installation 10 Design House • 262.518.1877 • www.todaysdesignhouse.
Deck Tile Installation Guide IMPORTANT NOTE (Read All Sections Before You Start) Before installing any composite product, it’s recommended that you check with local building codes for any special requirements or restrictions. The diagrams and instructions outlined in this guide are for illustration purposes only and are not meant or implied to replace a licensed professional. Any construction or use of these products must be in accordance with all local zoning and/or building codes.
Deck Tile Installation Guide Introduction Your new Design House Deck Tiles are crafted from recycled wood and plastic for a greener and more sustainable lifestyle. The tiles consist of wood-plastic composite (WPC) slats which are fastened by screws to a plastic base. wood-plastic slat screw plastic base Each deck tile side consists of two female (C-shape) and two male (T-shape) connection pieces, allowing you to create and customize your desired layout.
Deck Tile Installation Guide Installation Step 1: Prepare your surface Before beginning installation, sweep the surface, then check the surface grade or slope of the area you are working on to ensure it is level. If necessary, make repairs or modifications to the working surface area so that it is level. Pro tip: This is a great time to figure out what pattern you will be laying your deck tile.
Deck Tile Installation Guide Repeat the above step until the deck tile installation is completed. ① ② ③ Removing Tiles Step 1: If a tile needs to be removed, the best way is first to have one hand grip the tile to be removed and one hand holds the adjacent tile. Step 2: Pull the tile being removed upward while the other hand continues holding the adjacent tile. Step 3: If the tile connectors don’t disengage, immediately continue to wiggle the adjacent tile until all the tile connectors are separated.
Cutting Deck Tile Deck Tile Installation Guide These deck tiles can be cut to work around any corners or obstacles. Note: DHI cannot offer a refund or exchange for a product that has been cut. Step 1: Using a tape measure or ruler, measure the gap between the installed deck tile’s edge and the wall. Pro tip: Make sure to leave ¼ inch for expansion and contraction gaps. Expansion and Contraction Gap Design House • 262.518.1877 • www.todaysdesignhouse.
Deck Tile Installation Guide Step 2: Draw the cutting line on the underside of the deck tile according to the measured dimension. • Before cutting, always turn over the tile and ensure that the cutting lines do not cross over any screws. • Never cut any lines that have screws interfering, as they pose a risk of injury. • All deck tiles and trim must be cut according to this rule. Cut Line Design House • 262.518.1877 • www.todaysdesignhouse.
Deck Tile Installation Guide Complete the corners according to installation and cutting requirements. Design House • 262.518.1877 • www.todaysdesignhouse.
Fascia/Trim Installation Deck Tile Installation Guide The deck tile has two different trim options: straight trim and outward trim. If you need inward trim, it can be cut using the straight trim. Straight Trim Outward Left/Right Corner Trim Inward Left/Right Corner Trim Note: DHI cannot offer a refund for a product that has been cut unless the product has a manufacturing defect or is damaged upon delivery. Design House • 262.518.1877 • www.todaysdesignhouse.