Warranty

ManualsBrandsDesign Ideas ManualsGarage Shelves & RacksMeshWorks 4-Shelf Metal Silver Freestanding Utility Unit

MeshWorks

shelving

Parts List

Mesh Shelf

(A) x3

Mesh Half Shelf

(B)

Top Pole Section

Bottom Pole Section

(D) x2

Short Front Poles-35 3/8” long

(E) x2

Threaded Insert

(G) x2

Hook Rack

(F)

Leveling Foot

(J) x4

Shelf Clip

(H) 16 clips (32 pieces)

Wood Top

(K)

Plastic Cap

(I) x4

Scan here to watch the

instructional video.

! Do not throw away packaging materials

until assembly is complete.

! To clean, wipe with a soft, dry cloth.

Spot clean with a damp cloth if needed

Summary of content (4 pages)

PAGE 1
MeshWorks® shelving Parts List Mesh Shelf (A) x3 Bottom Pole Section (D) x2 Threaded Insert (G) x2 Mesh Half Shelf (B) Top Pole Section (C) x2 Short Front Poles-35 3/8” long (E) x2 Hook Rack (F) Shelf Clip (H) 16 clips (32 pieces) Plastic Cap (I) x4 ! Do not throw away packaging materials until assembly is complete. Leveling Foot (J) x4 Wood Top (K) ! To clean, wipe with a soft, dry cloth. Spot clean with a damp cloth if needed Scan here to watch the instructional video.
PAGE 2
Step 1 Attach the 2 top pole sections (C) to the 2 bottom pole sections (D) using the threaded inserts (G). Screw a leveling foot (J) into the bottom of each assembled pole and into the bottom of each shorter front pole (E). Bottom pole section (D) Bottom pole section (D) does not have groove. Leveling Foot (J) Pole (C & D) Assembly Step 2 Once poles are assembled, select the groove (spaced in 1” increments) where you’d like your lowest shelf to rest.
PAGE 3
Step 3 Once the shelves are in place, select the groove (spaced in 1” increments) where you’d like the hook rack (F) to rest. Position the two halves of your shelf clip (H) so that the beveled edge is facing the top. Snap the clip together around the pole and adjust until you feel it locate the groove. Once clips are snapped into place at equal heights on each of the 2 back poles, slide the hook rack down from the top to rest on the clips. Gently tap with a rubber mallet if needed to secure rack.
PAGE 4
Step 5 To add the wood top (K), simply rest it on top of the shelf. To clean, you may wipe with a clean, damp cloth. Step 6 With the unit fully assembled, press a plastic cap (I) into the hole in the top of each pole. To level your assembled unit, adjust the feet by twisting to the desired height. The designs, images, artwork, product descriptions and data shown in this document are protected by U.S.