Installation Guide

B. For walls with curves and/or angles it is recommended that you

layout the ﬁrst coarse of block for your wall before constructing

a curb.

C. Make sure the curved and/or angled sections of your opening or

curb are conﬁgured correctly.

D. The curb must be as wide as, or wider

than, the glass block thickness.

E. Apply ﬁnish material to the curb. If in-

stalling the glass blocks in a wet envi-

ronment, take steps to ensure that the

curb is waterproofed.

F. Use a level to make sure the opening is

level and plumb.

G. Verify all measurements. Remember, for rough opening’s total

height, add 1/4” to width measurement

H. If there are any problems with the opening or curb, adjust it before

proceeding.

I. Available shapes and ﬁnishing pieces,

with corresponding Series:

Block Shapes Series

Sharp Corner 80mm Pegasus Q19

Terminal Lineare (End) 80mm Pegasus Q19

Terminal Curvo (Dbl. End) 80mm Pegasus Q19