Installation Guide

ManualsBrandsDesign It ManualsGlass Block112024

etroQUICK

Glass Block Installation

System

simple,

quick,

safe, mortar-free

SEVES GLASS BLOCK

RGF INDUSTRIES, INC.

(412) 449-0044

FOR USE WITH DESIGN IT SERIES

GLASS BLOCK ONLY.

VetroQUICK is not approved for use in projects requiring

safety glazing. The user is responsible for determining if

their project needs to meet safety glazing specifications.

Glass Block

Installation System

Summary of content (6 pages)

PAGE 1
Glass Block Installation System VetroQUICK Glass Block Installation System simple, quick, safe, mortar-free FOR USE WITH DESIGN IT SERIES GLASS BLOCK ONLY. SEVES GLASS BLOCK RGF INDUSTRIES, INC. (412) 449-0044 VetroQUICK is not approved for use in projects requiring safety glazing. The user is responsible for determining if their project needs to meet safety glazing specifications.
PAGE 2
VetroQUICK is a dry installation system for creating glass block walls simply, quickly and safely. VetroQUICK simplifies installation with the use of a few accessories: A Profile and a Cross Connector.
PAGE 3
INSTALLATION INSTRUCTIONS ᬛ ᬚ Prepare the cross connectors Insert a profile into the “L” cross. This combination of a “L” cross and profile will start the bottom corner of your project. By sliding one leg into another, prepare an “L” cross for each of the bottom corners of your project. Prepare “T” crosses, one for each glass block in your first course. Preparing an “L” cross ᬜ Add profiles to crosses Then insert the opposite end of the profile into a “T” cross.
PAGE 4
INSTALLATION INSTRUCTIONS ᬢ Start The Next Course Create another strip of profiles and “+” cross connectors the length of your project. Use “T” crosses on the end(s) of the strip that will be in contact with a wall or jamb. ᬣ Connect the “+” shaped connectors to the vertical profiles which are now between each glass block by gently tapping with a rubber mallet. NOTE: Always check for square & plumb as you complete each course ᬤ Add more vertical profiles by sliding the profile into the “+” connectors.
PAGE 5
FINISH SPECIAL NOTES AND RECOMMENDATIONS: Joints may be finished with a sanded or urethane grout. Urethane Grout Finish Follow directions for mixing, application and cleaning on the grout packaging.
PAGE 6
TABLE OF USE AND MEASUREMENTS Height (# of blocks) No. of profiles S eves S.p.A. 10 31 9 28 8 25 7 22 6 19 5 16 4 13 3 10 2 7 1 4 Length (# of blocks) 33 30 10 8 4 1 2 3 4 5 For larger surfaces, specific structural calculations are needed.