Operating Guide
16
•For the two bottom corners of the panel, orient
the spacer with the cross arm down and clip off
the upper toothed legs. Clip off the upper half of
the twist-off tabs. Cut off the left or right side of
the remaining twist-off tab and the smooth legs on
the same side. Only two of these spacers
are required. Clip off the right set of smooth legs
of one spacer, the left set of the other spacer.
These are called “L”.
2.
Preparation of Universal Mortar Spacers,
Panel Anchors, and Expansion Strips
A. Assemble the spacers for the series of block you are
installing. The spacers come in two
halves, snap the spacers together to
ÀWWKHZLGWKRIWKHEORFN
2A
B. Modify the spacers using tin snips based on
their location:
• Where four block come together spacers are used
as assembled. These are
called “REGULAR”.
“REGULAR” Spacer
“REGULAR” Spacer
0RGLÀHG&DOOHG“L”