Installation Guide

INSTALLATION
INSTRUCTIONS
❾ ❿
⓬
⓫
NOTE: Always check for square & plumb as
you complete each course
Start The Next Course
Create another strip of profiles and “+” cross connectors
the length of your project. Use “T” crosses on the end(s)
of the strip that will be in contact with a wall or jamb.
Connect the “+” shaped connectors to the vertical profiles
which are now between each glass block by gently tapping
with a rubber mallet.
NOTE:
Make sure the leg of the
connector is aligned with
the vertical profiles before
using the mallet. (The leg
must “clip” over the end of
the profile in order to
securely hold your project.
Correct Incorrect
Leg to Profile Attachment
Add more vertical
profiles by sliding the
profile into the “+”
connectors.
NOTE:
As you progress with each
course, the vertical profiles
positioned against the wall or
jamb must be securely
screwed into place before
setting the glass blocks.
The first course is
now complete.
Repeat until your
project is complete.
Continue assembling profiles,
cross connectors and glass
blocks until your project is
built.