Installation Manual

FOR
YOUR
T H A N K YOU
P U R C H A SE
1 . 8 0 0 . 5 2 5 . 0 7 3 3
DESIGNTOSCANO.COM
©Copyright 2014, Design Toscano, Inc.
Wall Hanging Instructions
FOR
YOUR
INSTRUCTIONS
PRODUCT
Using the drill bit size
recommended on your
wall anchor hardware, (not
included) drill a hole equal
to the depth of your anchor.
*Anchor hardware should
be rated for the weight
of your artwork or more.
Step 1 Step 2
Step 3 Step 4
Insert anchor into hole.
Insert screw into anchor
leaving a minimum of
5
/16
”
of mounting screw
exposed from wall.
Line up screw with the round
opening of the keyhole slot,
then slide artwork down
so screwhead is locked
into place.
Locate desired position
on wall for hanging.
If wall stud is present,
drill screw(s) directly
into stud, and proceed
to step 4.
If no stud is found,
follow steps 1-4.
Repeat these steps as
needed for multiple
hangers. Be sure holes
are level and spaced
correctly by measuring
the distance between
keyhole slots (on
center). Check your
markings with a level
before drilling.
Please note, these
instructions are meant
for common drywall
walls. If other conditions
are present, check
with your local
hardware store for
recommendations
on hardware and
hanging methods.