Technical data

A100 OPERATING MANUAL

SET CONSERVATIVE FACTOR, information is to include (Fig. 32):

> Graphic CONS with SET and CF icons.

> Graphic OFF (or ON) ﬂashing.

• B (< 2 sec) to toggle between OFF and ON.

• B (2 sec) to save the setting and revert to Set UTL Lead-in.

When the Conservative Factor is set ON, NDLs, which are to be based on the Algorithm selected (DSAT or Z+), are reduced to

the values available at the next higher (+ 3000 feet) Altitude. Ex: NDLs for Sea Level shift to those listed for the 5001 to 6000

foot Altitude range.

ID - SN (Identiﬁcation), information includes (Fig. 33):

This information should be recorded and kept, it will be required in the event that your unit requires factory service.

> Graphic R1A (or higher)*, indicating the Firmware revision level currently installed in the unit.

> Factory programmed serial number (up to 5 digits) with # icon.

*This number will change if the Firmware is updated with a newer version.

• B (< 2 sec) to revert to Surface Main.

• B (2 sec) to access Clear, only after dives when residual nitrogen remains.

• 2 minutes, revert to Main if B is not pressed.

CLEAR, information includes (Fig. 34):

The unit is conﬁgured with a feature that allows nitrogen and oxygen calculations to be cleared.

This is intended for facili-

ties using the unit for rental or training activities, not for general use by individual divers.

WARNING: Reset after a dive and subsequent use for a repetitive dive conducted by the same diver

could result in serious injury or death.

Reset procedure:

• B (2 sec), while the ID-SN screen is displayed, to access the Clear screen displaying the graphic CLR and the reset code

numbers xx yy, all solid.

• B (2 sec) again will ﬂash the ﬁrst 2 digits (xx).

• B (< 2 sec, repeatedly) to step upward through the ﬁrst digits (xx) from 01 to 49.

• B (2 sec) to save the ﬁrst 2 digits (xx) and ﬂash the second 2 digits (yy).

• B (< 2 sec, repeatedly) to step upward through the second digits (yy) from 01 to 49.

• B (2 sec) to save the reset code, clear the unit (if 20 02), and turn it Off. All nitrogen/oxygen calculations and data will be

deleted.

• B (6 sec) will revert to the ID-SN screen, if the reset code is not entered correctly, or you want to exit the routine without

clearing the unit.

Fig. 32 - SET CF

(Conservative Factor)

Fig. 33 - IDENTIFICATION

Fig. 34 -CLEAR