Product Info
Table Of Contents
- 1.1 About this manual 2
- 1.2 Explanation of signal words and symbols 2
- 1.3 Customer service & service 3
- 2.1 Intended use 4
- 2.2 Warnings and occupational health and safety 4
- 2.3 Safety standards 5
- 5.1 Technical requirements 7
- 5.2 SQL database configuration 7
- 5.3 System software 7
- 8.1 Installation 12
- 9.1 Configuration at the factory 18
- 9.2 Retrofitting the IN and OUT devices with SMART MOVE 18
- 9.3 Decommissioning and disassembly 19
- 9.4 Disposal 19
- 1 General
- 2 Safety
- 3 Scope of delivery
- 4 SMART MOVE system
- 5 System requirements
- 6 Technical Data
- 7 Configuring beacons
- 8 Installing beacons in the lane
- 9 Configuring the IN and OUT devices
- 10 Version overview
6 Technical Data
10 © DESIGNA Verkehrsleittechnik GmbH
DESIGNA SMART MOVE_Installation_110_ENG.docx
6 Technical Data
Dimensions
Fig. 3: Beacon box, dimensions in mm
Design
ABS (black)
7 Configuring beacons
The beacon is housed in a plastic box and preconfigured at the factory.
Prior to delivery, the latest software is installed on the beacon before it is
configured and tested for the customer. This ensures the beacon is
always ready for use upon delivery.
Configuration
The beacon on the terminal and the beacon in the DCT column are
equipped with the latest firmware at the factory.
As part of the factory configuration, the beacons receive a unique
identification number. This identification number is subsequently used by
the app to recognise the beacon. A label with the assigned ID number is
affixed to the beacon box to guarantee correct beacon installation in the
right lane.