Product Info
Table Of Contents
- 1.1 About this manual 2
- 1.2 Explanation of signal words and symbols 2
- 1.3 Customer service & service 3
- 2.1 Intended use 4
- 2.2 Warnings and occupational health and safety 4
- 2.3 Safety standards 5
- 5.1 Technical requirements 7
- 5.2 SQL database configuration 7
- 5.3 System software 7
- 8.1 Installation 12
- 9.1 Configuration at the factory 18
- 9.2 Retrofitting the IN and OUT devices with SMART MOVE 18
- 9.3 Decommissioning and disassembly 19
- 9.4 Disposal 19
- 1 General
- 2 Safety
- 3 Scope of delivery
- 4 SMART MOVE system
- 5 System requirements
- 6 Technical Data
- 7 Configuring beacons
- 8 Installing beacons in the lane
- 9 Configuring the IN and OUT devices
- 10 Version overview
Installing beacons in the lane 8
© DESIGNA Verkehrsleittechnik GmbH 13
DESIGNA SMART MOVE_Installation_110_ENG.docx
8.1.1 Installing the beacon box on the entrance /exit control terminal
The beacon is housed in a plastic box and installed on the side of the
device facing the barrier.
Power is supplied by the device.
Fig. 5: Beacon box on device
Holes on the entrance /exit
control terminal
1. Drill three holes in the device (see figure below):
Two holes for installation on the device
One hole for the cable duct
Fig. 6: Beacon box installation on entrance /exit control terminal– holes
(dimensions in mm)
2. Open the beacon box to screw the box to the device.