Installation Instructions

6
1.
Establish the placement of the bottom
of the level panel based on your
desired rail height. Mark a line on
your mounting surface at this height
plus 1 1/8" to represent the top of the
mounting bracket (Fig. 23).
Make an intersecting mark representing
the desired center line of your installed
rail panel. Set the bracket in place
orienting the notch in the top of the
bracket to the center mark and attach
using 2 fasteners appropriate for the
material to which you are installing the
bracket (Fig. 24).
1.
The angle bracket is the same bracket
as the stair bracket described above.
Angle mounting varies greatly on each
installation.
Test t your rail panels and cut to
length for your specic installation.
Follow the general methods described
above to complete your angle
installation (Figs. 27 & 28).
2.
Mark the post 34 1/8" (34 1/8" for
34" high panels or 40 1/8" for 40"
high panels) from the bottom bracket
attached in Step 1 (Figs. 25 & 26).
Make an intersecting mark representing
the desired center line of your installed
rail panel (this mark is the top of the
bracket). Attach the top bracket as you
did the bottom in step 1.
Refer to Step 2 in the Designers' Image
Level Rail Panel instructions to complete
your installation from this point.
(Fig. 24)
(Fig. 26)
(Fig. 23)
2
3
4
(Fig. 25)
(Fig. 27)
(Fig. 28)
LEVEL & ANGLE BRACKET INSTRUCTIONS