Installation Instructions

5
4.
Insert the cut panel ends into the stair
brackets ensuring all are properly
oriented. Test the panel to ensure
proper t. Mark the position of the
bracket on all 4 posts (Fig. 16).
Once proper t is ensured remove the
brackets from the rail panel and paint
all cuts (Fig. 17).
Reinsert the painted panel ends into
the brackets and pre-drill the screw
holes using a 5/32" metal drill bit.
Secure using the supplied self-tapping
panel attachment screws through the
pre-drilled bracket holes (Fig. 18).
5.
Separate the two bracket halves at all
rail ends. Install the post half of each
mounting bracket at the marks made
in step 3 (Fig. 19) ensuring all brackets
are properly oriented. Now set the
panel back into place and re-attach the
bracket halves (Fig. 20).
6.
Assemble the 2 piece post trim cover
by inserting one fastener in each trim
half (Fig. 21). Snap these in place (Fig.
22) concealing the post ange.
(Fig. 16)
(Fig. 17)
(Fig. 18) (Fig. 20)
(Fig. 22)
(Fig. 19)
(Fig. 21)
STAIR RAIL INSTRUCTIONS