SDS
PFB706S4
SAFETY DATA SHEET
PFB706S4 v2.0
en/US
Requirements for storage areas and containers
Observe label precautions. Store in a dry, well ventilated place away from sources of heat, ignition and direct sunlight. No smoking.
Prevent unauthorized access. Containers which are opened must be carefully resealed and kept upright to prevent leakage.
Advice on common storage
Store separately from oxidizing agents and strongly alkaline and strongly acidic materials.
8. Exposure controls/personal protection
Engineering controls and work practices
Do not breathe dust. Provide adequate ventilation. This should be achieved by a good general extraction and -if practically feasible-
by the use of a local exhaust ventilation. If these are not sufficient to maintain exposure to dusts below the OEL, suitable respiratory
protection must be worn.
National occupational exposure limits
CAS-No. Chemical Name
Source
Time Type Value Note
65997-17-3 Glass oxide ACGIH 8 hr TWA 10 mg/m3 inhalable
dust
OSHA 8 hr TWA 15 mg/m3 Total Dust
8 hr TWA 5 mg/m3 Respirable
Dust
Dupont 8 & 12
hour
TWA 2 fibers/ml Respirable
Dust
8 & 12
hour
TWA 5 mg/m3 non fibrous
particulate
** TWA = Time-weighted average.
Protective equipment
Personal protective equipment should be worn to prevent contact with eyes, skin or clothing.
Respiratory protection
Should any dust be generated, it should not be breathed. If a respirator is needed to meet applicable exposure limits, wear a properly
fitted air-purifying respirator approved by NIOSH. Follow respirator manufacturer s directions for respirator use. Do not breathe
dust. If respirator is required to meet applicable exposure limits, use a NIOSH approved TC-84A respirator in accordance with
regulatory requirements (in the US follow OSHA standard 29CFR1910.134) and the respirator manufacturer’s directions.
Eye protection
Desirable in all industrial situations.
Skin and body protection
Gloves are recommended
Hygiene measures
Wash skin thoroughly with soap and water or use recognized skin cleanser. Do NOT use solvents or thinners.
Environmental exposure controls
Do not let product enter drains. For ecological information, refer to Ecological Information Section 12.
c
2015 Axalta Coating Systems, LLC and all affiliates. All rights reserved.
Copies may be made only for those using Axalta Coating Systems products.
4 - 9
2015-05-13