Installation Instructions

Warning: Always wear safety goggles.
1.
Measure opening between posts where gate
will be located. Subtract 4
"
from opening.
This will be the length you will cut your rail
panel for gate (Fig. 1).
Note:
When marking rail, you must leave a
minimum of 1
1
⁄
1
⁄
1
2
⁄2⁄
"
and a maximum of 2
7
⁄
7
⁄
7
8
⁄8⁄
"
to
the fi rst baluster at each end (Fig. 2). This will
allow suffi cient railing for the gate ends to fi t
to.
2.
Confi rm your marks and cut the panel to fi t
using a jig saw with metal blade or a portable
band saw. All cuts must be painted prior to
fi nal assembly.
Note:
Rail ends may be painted with any zinc
rich primer or paint.
Fully insert the panel ends into the gate
ends (Fig. 3). Clamp or strap the assembly
together and ensure that it is square.
3.
Pre-drill one hole on the underside of the
top and bottom rails using a
5
⁄
5
⁄
5
32
⁄32⁄
"
bit (Fig. 3, A).
Fasten the gate ends to the panel using the
hardware provided (#10 x
3
⁄
3
⁄
3
4
⁄4⁄
"
Phillips Pan
Head Screws). Install gate to post using gate
hardware (sold separately).
Tip:
If scratching occurs, Barrette Outdoor
Living recommends Rust-Oleum
®
, Satin
Canyon Black, Color Code 249844 for
Black. For Bronze touch-ups, Rust-Oleum
®
,
Hammered Brown, Color Code 210880 is
recommended.
(Fig. 1)
(Fig. 2)
(Fig. 3)
Measure
Mesure
1½" – 2
7
∕
7
∕
7
8
∕
8
∕
"
38,1mm – 72mm
A
GATE ENDS
INSTALLATION INSTRUCTIONS
To obtain and review a copy of the warranty please go to: BarretteOutdoorLiving.com/warranty. You can
also contact
1-800-336-2383
or write to Barrette Outdoor Living, 7830 Freeway Circle, Middleburg Heights,
Ohio 44130 to obtain a copy of the warranty.